T-1 3/4 (5mm) SOLID STATE LAMP ATTENTION W7114PWC/H WHITE OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Features Description LOW POWER CONSUMPTION. The source color devices are made with InGaN on SiC Light POPULAR T-1 3/4 DIAMETER PACKAGE. Emitting Diode. GENERAL PURPOSE LEADS. Static electricity and surge damage the LEDS. RELIABLE AND RUGGED. It is recommended to use a wrist band or LONG LIFE - SOLID STATE RELIABILITY. anti-electrostatic glove when handling the LEDs. AVAILABLE ON TAPE AND REEL. All devices, equipment and machinery must be electrically grounded. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge package. 4. Specifications are subject to change without notice. SPEC NO: DSAC7397 REV NO: V.1 DATE: MAY/29/2003 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.H.LI PAGE: 1 OF 3 Selection Guide Part No. Dice W7114PWC/H Iv (mcd) @ 20mA Lens Type WHITE (InGaN) WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 2800 4000 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device VF Forward Voltage White IR Reverse Current White Chromaticity Coordinates White X Typ. Max. Units Test Conditions 3.7 4.3 V IF=20mA 10 uA VR = 5V pF VF=0V;f=1MHz 0.33 Y C 0.34 Capacitance White 110 Absolute Maximum Ratings at TA=25°C White Units Power dissipation 108 mW DC Forward Current 30 mA Peak Forward Current [1] 100 mA 5 V Parameter Reverse Voltage Operating Temperature -40°C To +85°C Lead Solder Temperature[2] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. SPEC NO: DSAC7397 REV NO: V.1 DATE: MAY/29/2003 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.H.LI PAGE: 2 OF 3 White W7114PWC/H SPEC NO: DSAC7397 REV NO: V.1 DATE: MAY/29/2003 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.H.LI PAGE: 3 OF 3