Current Transducers HAS 50..600-P IPN = 50..600 A For the electronic measurement of currents: DC, AC, pulsed, mixed, with a galvanic isolation between the primary circuit (high power) and the secondary circuit (electronic circuit). VOUT = ±4 V Electrical data Primary nominal r.m.s. current IPN (A) Primary current measuring range IP (A) ±150 ±300 ±600 ±900 ±900 ±900 ±900 50 100 200 300 400 500 600 VC IC IOC Vd Vb RIS VOUT ROUT RL Type HAS HAS HAS HAS HAS HAS HAS Features 50-P 100-P 200-P 300-P 400-P 500-P 600-P • Hall effect measuring principle • Galvanic isolation between primary and secondary circuit Supply voltage (± 5 %) Current consumption Overload capacity R.m.s. voltage for AC isolation test, 60 Hz, 1 mn R.m.s. rated voltage, safe separation Isolation resistance @ 500 VDC Output voltage @ ± IPN, RL = 10 kΩ, TA = 25°C Output internal resistance approx. Load resistance ±15 ±15 30,000 3 5001) > 1000 ±4V ±40 100 >1 V mA At kV V MΩ mV Ω kΩ • Isolation voltage 3000 V~ • Low power consumption • Extended measuring range (3 x IPN) • Insulated plastic case made of polycarbonate PBT recognized according to UL 94-V0 • Right angle pins for direct PCB mounting Advantages Accuracy - Dynamic performance data X ε Accuracy @ IPN, TA = 25°C (without offset) Linearity 2) (0 .. ± IPN) Electrical offset voltage, TA = 25°C Hysteresis offset voltage @ IPN→ 0 Thermal drift of VOE HAS 50-P L VOE VOH VOT HAS 100..600-P TCε G tr di/dt f Thermal drift of the gain (% of reading) Response time @ 90% of IP di/dt accurately followed Frequency bandwidth (small signal, -1dB) 3) 4) < ±1 % < ±1 % of IPN < ±40 mV < ±20 mV < ±2 mV/K < ±1 mV/K < ±0.1 %/K <3 µs > 50 A/µs DC .. 25 kHz General data TA TS m Ambient operating temperature Ambient storage temperature Mass Standards 5) - 25 .. + 85 °C - 25 .. + 85 °C approx. 80 g EN 50082-2 • Easy mounting • Small size and space saving • Only one design for wide current ratings range • High immunity to external interference. Applications • AC variable speed drives • Static converters for DC motor drives • Battery supplied applications • Uninterruptible Power Supplies (UPS) • Switched Mode Power Supplies (SMPS) • Power supplies for welding applications. Notes : 1) 2) 3) 4) 5) Pollution class 2, overvoltage category III. Linearity data exclude the electrical offset. Please refer to derating curves in the technical file to avoid excessive core heating at high frequency. Amorphous core option for high frequency application. Please consult characterisation report for more technical details and application advice. LEM Components 040406/0 www.lem.com HAS 50..600-P Dimensions (in mm) PINS ARRANGEMENT 1. 2. 3. 4. LEM reserves the right to change limits and dimensions. +15V –15V OUTPUT 0V