www.make-ps.com E-mail:[email protected] 100VFS series Single & Dual Output DC/DC Converter F EATURES • • • • • • HIGH ISOLATION - 3000 VDC Up to 81 % Efficiency Single and Dual Output, 1 watt converter Available in 5, 12, and 24 VDC Inputs Miniature Package SMT Technology DESCRIPTIONS INPUT CHARACTERISTICS The 100VFS 1 Watt DC/DC’s are specially designed to provide ultra-high levels of isolation 3000VDC in a miniature SIP package. The series consists of 27 models with input voltages of 5V, 12V and 24V, and offers standard output voltages of 3.3V, 5V, 9V, 12V, 15V, ±5V, ±9V, ±12V, and ±15V for a wide choice. Min Input Voltage 5 VDC Input Models 4.5 12 VDC Input Models 10.8 24 VDC Input Models 21.6 Input Fuse Requirements 5 VDC Input Models 12 VDC Input Models 15 VDC Input Models Reverse Polarity Input Current Input Filter The 100VFS series is an excellent selection for a variety of applications including distributed power systems, mixed analog/digital subsystems, portable test equipment, local power networks and battery backed systems. Typ Max Unit/Comments VDC VDC VDC 5 12 24 5.5 13.2 26.4 500 200 100 mA; Slow blow type mA; Slow blow type mA; Slow blow type 0.3 Amp Input Capacitor OUTPUT CHARACTERISTICS Output Voltage Set Point Output Voltage Balance (Duals) Line Regulation Load Regulation Ripple/Noise Ripple/Noise Short Circuit Protection Temperature Coefficient Min Typ Max Unit/Comments ±1.0 ±3.0 % Output voltage at nominal line & FL ±0.1 ±1.0 % Equal Output Loads ±1.2 ±1.5 %; % Change / Percentage change in Input voltage See % Output voltage Model Selection measured from FL Guide to 20% load 65 100 mV p-p, Nom.Line @FL, 20MHz B.W., using 1 μf bypass capacitor 150 mV p-p, Over Line, Load & Temp., 20 MHz B.W., using 1 μf bypass capacitor <0.5 Second, Momentary ±0.01 ±0.02 % per degree C GENERAL CHARACTERISTICS Switching Frequency Isolation Voltage Isolation Resistance Isolation Capacitance MTBF (MIL-HBK-217F) Min Typ Max Unit/Comments kHz 70 100 120 VDC, 1 minute 3000 Mohm, 500VDC 10,000 60 100 pF, 100kHz, 1Volt Million Hours, 2 +25oC, Ground Benign >> B-9 www.make-ps.com E-mail:[email protected] ENVIRONMENTAL SPECIFICATIONS Operating Temp. Range Storage Temp. Range Relative Humidity Min -25 -40 PHYSICAL CHARACTERISTICS Typ Max +85 +125 +95 Cooling Unit/Comments o C; Ambient o C % Humidity; noncondensing Free-Air Convection Case Size 5V & 12V Input 24V Input Case Material Flammability Weight 5V & 12 V Input 24V Input Unit/Comments 0.77 X 0.24 X 0.40 inches (19.5 X 6.1 X 10.2 mm) 0.77 X 0.28 X 0.40 inches (19.5 X 7.1 X 10.2 mm) Non-Conductive Black Plastic UL94V-0 2.2 Grams 2.6 Grams OUTLINE DRAWING SIDE VIEW 0.300 (7.62) 0.40 (10.2) 0.02 (0.5) 0.77 (19.5) 0.13 (3.2) 0.100 (2.54) TYP 0.08 (2.1) 0.73 (18.5) BOTTOM VIEW 0.24 (6.1) - 5V & 12V 0.28 (7.1) - 24V 0.020 (0.50) 0.05 (1.3) 5 6 7 0.010 (0.25) 1 2 PIN OUT CHART Pins 1 2 5 6 7 Single + Vin - Vin - Vout No Pin + Vout Dual + Vin - Vin - Vout Common + Vout Notes: 1. Unless otherwise specified dimensions are in inches (mm). Tolerances Inches mm X.XX = ±0.02 X.X = ±0.5 X.XXX= ±0.010 X.XX = ±0.25 Pin : ±0.002 ±0.05 All specifications are typical at nominal input, nominal load and 25° C unless otherwise specified. External, low ESR, 10 microfarad (minimum) capacitor across output is recommended for operation. >> B-10 www.make-ps.com E-mail:[email protected] HOW TO ORDER HOW TO ORDER 1 XX S XX VFS - Y ROHS Compliant Series Nominal Input Voltage Wattage Output Voltage Output Configuration (S=Single, D=Dual) MODEL SELECTION CHART Model 103S5VFS 105S5VFS 109S5VFS 112S5VFS 115S5VFS 105D5VFS 109D5VFS 112D5VFS 115D5VFS 103S12VFS 105S12VFS 109S12VFS 112S12VFS 115S12VFS 105D12VFS 109D12VFS 112D12VFS 115D12VFS 103S24VFS 105S24VFS 109S24VFS 112S24VFS 115S24VFS 105D24VFS 109D24VFS 112D24VFS 115D24VFS Nominal Input Voltage (VDC) 5 5 5 5 5 5 5 5 5 12 12 12 12 12 12 12 12 12 24 24 24 24 24 24 24 24 24 Output Voltage (VDC) 3.3 5 9 12 15 ±5 ±9 ±12 ±15 3.3 5 9 12 15 ±5 ±9 ±12 ±15 3.3 5 9 12 15 ±5 ±9 ±12 ±15 Full Load Output Current (mA) 260 200 110 84 67 ±100 ±56 ±42 ±34 260 200 110 84 67 ±100 ±56 ±42 ±34 260 200 110 84 67 ±100 ±56 ±42 ±34 No Load Input Current (mA) 30 30 30 30 30 30 30 30 30 12 12 12 12 12 12 12 12 12 7 7 7 7 7 7 7 7 7 Full Load Input Current (mA) 235 281 260 258 258 278 262 258 258 96 114 106 105 104 113 106 104 105 49 59 54 54 53 58 55 53 53 Load Efficiency Regulation @ FL Max. (%) (%) 10 73 10 71 8 76 7 78 7 78 10 72 8 77 7 78 7 79 8 74 8 73 5 78 5 80 5 80 8 74 5 79 5 81 5 81 8 73 8 71 5 76 5 78 5 79 8 72 5 76 5 79 5 80 >> B-11 www.make-ps.com E-mail:[email protected] DERATING CURVES MODEL 100VFS (3.3V, 5V & ±5V) Pout % 100 90 80 70 60 50 40 30 20 10 0 -40 50 100LFM 200LFM Natural Convection 400LFM 60 70 80 90 100 110 TEMPERATURE ° C MODEL 100VFS (All other outputs) Pout % 100 90 80 70 60 50 40 30 20 10 0 -40 400LFM 200LFM 100LFM Natural Convection 50 60 70 80 90 100 110 TEMPERATURE ° C >> B-12