Xeon 1 Power Pure Green &Red & Blue LED OSTCXBEAC1E-N VER.A.2 ■Features Highest Luminous Flux ● Long Lifetime Operation ● Superior ESD protection ● Superior UV Resistance ● 2.75 ● ● ● ● ● Red Anode Mark Water Clear Type 4 3 Mobile Phone Flash Automotive Interior/Exterior Lighting / Signal Lighting Architectural Lighting LCD TV / Monitor Backlight Projector Light Source / Traffic Signals / Task Lighting Decorative / Pathway Lighting / Household Applications ■Absolute 6 0.2 ■Applications ● 5.3 1.0 14.5 Super Energy Efficiency 4.4 3 2 1 5.0 ● Dimension 7.3 ● ■Outline Maximum Rating Item Symbol 4 6 R 5 Back View 1 2 B (Ta=25℃) Value Green/Blue Red 5 G 4,5,6.Anode 1,2,3.Cathode Unit:mm Tolerance±0.30mm 6 ■Directivity Unit DC Forward Current IF 400 400 mA Pulse Forward Current* IFP 500 500 mA Reverse Voltage VR 5 5 V Power Dissipation PD 1200 1600 mW Operating Temperature Topr -30 ~ +85 ℃ Storage Temperature Tstg -40 ~ +100 ℃ Lead Soldering Temperature Tsol 260℃/5sec - 0 0 *Pulse width Max.10ms Duty ratio max 1/10 ■Electrical -Optical Characteristics Item DC Forward Voltage DC Reverse Current Domi. Wavelength Luminous Flux 50% Power Angle (Ta=25℃) Symbol Condition Min. Typ. Max. Unit VF (R) IF=350mA 2.0 2.5 3.0 V VF (B/G) IF=350mA 3.0 3.3 4.0 V IR VR=5V - - 10 µA λD(Red) IF=350mA 620 625 630 nm λD(Green) IF=350mA 520 525 535 nm λD(Blue) IF=350mA 455 460 465 nm Φv (Red) IF=350mA 40 50 - lm Φv (Green) IF=350mA 80 95 - lm Φv (Blue) IF=350mA 15 20 - lm 2θ1/2 IF=350mA - 120 - deg Note: Don’t drive at rated current more than 5s without heat sink for Xeon 1 Power emitter series. LED & Application Technologies http://www.optosupply.com VER A.0 Xeon 1 Power Pure Green &Red & Blue LED OSTCXBEAC1E-N VER C.0 ■ Soldering Heat Reliability (DIP): Reflow soldering Profile · Reflow soldering should not be done more than two times. · When soldering, do not put stress on the LEDs during heating. · After soldering, do not warp the circuit board. · Repairing should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing. Solder Average ramp-up rate = 3ºC/sec. max. Preheat temperature: 150º~180ºC Preheat time = 120 sec. max. Ramp-down rate = 6ºC/sec. max. Peak temperature = 220ºC max. Time within 3ºC of actual peak temperature = 25 sec. max. Duration above 200ºC is 40 sec. max. LED & Application Technologies http://www.optosupply.com VER A.0