I/Q Mixer / Modulator Model MIQ5xSMD-1 Communications Band RF 5.6 to 9.0 GHz Electrical Specifications: (1) Specifications Conditions Parameter SSB Conversion loss: (2) (3) Image Rejection Sideband Suppression: (4) Amplitude Match Phase Match Isolation LO to RF: LO to I/Q: RF to I/Q: I/Q to RF: Input 1 dB Compression Point: RF (GHz) 5.6-9.0 LO (GHz) 5.6-9.0 IF (MHz) DC-500 Min Typical 5.0 dB 5.8-8.8 5.6-9.0 5.6-9.0 5.6-9.0 5.8-8.8 5.6-9.0 5.6-9.0 5.6-9.0 DC-500 DC-500 DC-500 DC-500 22 dB 18 dB 33 dB 32 dB 0.2 dB 3 deg 25 dB 25 dB 31 dB 40 dB 26 dB 40 dB +5 dBm +8 dBm +12 dBm +14 dBm +17 dBm +21 dBm +10 dBm +13 dBm +17 dBm 5.6-9.0 5.6-9.0 5.6-9.0 5.6-9.0 5.6-9.0 DC-500 DC-500 Input Third Order Intercept Point: 5.6-9.0 5.6-9.0 DC-500 LO Power: (5) 5.6-9.0 5.6-9.0 DC-500 Notes: 1. Specifications are guaranteed when tested as a downconverter in a 50 Ohm system at +25˚C with the nominal LO power. Specifications indicated as typical are not guaranteed. 2. Noise figure is typically within ±0.5 dB of conversion loss for IF frequencies greater than 10 MHz. 3. Conversion loss typically degrades less than 0.5 dB at +100˚C and improves less than 0.5 dB at -55˚C. Conversion loss is the combined value. 4. Measured with an IF quadrature hybrid whose amplitude and phase errors are 0.5 dB and 3 degrees maximum. An IF quadrature hybrid is not included. 5. Usable LO drives are up to 2 dB below to 3 dB above nominal. 6. See Application notes M112, for aid in selecting the outline and for mounting and installation information. MIQ5xSMD-1 Model MIQ5xSMD-1 Max 6.5 dB LO Power 4 = +10 dBm 6 = +13 dBm 7 = +17 dBm MIQ54 MIQ56 MIQ57 MIQ54 MIQ56 MIQ57 MIQ54 MIQ56 MIQ57 Typical Performance at 25˚C Outline: SMQD7 All dimensions are in inches and [mm]. Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, FL 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, PA 19154 · PH (215) 464-4000 · Fax (215) 464-4001 Rev. 10/8/08