Industrial Power Supply MPI-8080 80W AC-DC Open Frame Power Supply Output 100W with Fan Required E 1 N 8.38 L TB1 TRANSFORMER 12 TB2 15.24 14.44 1.4 Measuring the screw protrusion first: Use #6-32 screw Protrusion limits 2.5mm x4 Features *Input Voltage: 85~264VAC *Input Frequency: 47~63Hz *Input Current: 3A at 115VAC or 1.5A at 230VAC max. capacitors *Inrush Current: Does not exceed 30A at 115VAC input or 60A at 230VAC input, cold start at 25oC *Load Regulation: With +5V output set between 4.95~5.05V and all output at 60% rated load, and all other outputs in the accuracy range, max. load can not > 80W convection cooling and > 100W forced air cooling *Ripple And Noise: Peak to peak ripple and noise for each output is < 1% of each output voltage at rated load *Line Regulation: < +/-1% at rated load with +/-10% change in input voltage *Load Regulation: < +/-1% for +5V, < +/-5% for other outputs with +/-40% change in measured output loading from 60% rated load and other outputs at 60% rated laod *Hold Up Time: > 16ms at 115VAC input and rated load *Efficiency: > 70% at nominal line and rated load *Altitude: 10,000 feet *Protection: Short Circuit: Hiccup mode against short circuit or over load conditions auto recovery to normal after wrong conditions are removed Output: Built-in crowbar circuit shuts down outputs to avoid damage. Trip point of over voltage protection is between 5.7~7.0V AC line ON/OFF restarts and recovers the unit from over voltage protection *Temperature: 0~+50oC, requires forces air of 30CFM for outputs > 80W (operating); -20~+70oC (storage) *Humidity: 5~95%; non-condensing at 40oC (operating) *Dimensions: 15.24 x 8.38 x 3.8 cm within +/-0.4mm tolerance *MTBF: 283,179 hrs. www.boser.com.tw 6.85 screw System chassis Safety Standards *Safety: UL 1950 / CSA 22.2 No.234 / VDE EN60950 *EMI: FCC class B / EN55022 B *EMS: Level 3 of IEC-801, 802, 803, 804 PIN 1~3 4~7 8~9 10 11 12 Output +5V GND +12V -12V -5V N/C Output Min. Voltage Load +5V 1A +12V 0A -12V 0A -5V 0A Rated Load 6A 3.5A 0.5A 0.5A PIN 1 2 3 Max. Load 10A 6A 1A 1A Input AC Line-1 AC Line-2 GND Tolerance +/-0.05V +/-0.75V +/-0.75V +/-0.25V 2.5 AC-DC 6.85 0.765 3.3 3.8 3.97 0.4