100W AC-DC Open Frame ATX Power Supply Requiring 18CFM Forced Air Cooling E TRANSFORMER 24V 0.8 0.8 6.78 0V 0.55 6.78 Industrial Power Supply 14.14 8.38 BPW-8310 15.24 0.4 3.3 3.8 1.4 0.765 1.5 AC-DC 3.15 14.44 Use #6-32 screw Protrusion limits 2.5mm x4 Features screw System chassis 6.85 3.87 Safety Standards *Safety: UL 1950 / CSA 22.2 No.234 / VDE EN60950 *Input Voltage: 85~264VAC *EMI: FCC class B / EN55022 B *Input Frequency: 47~63Hz *EMS: Level 3 of IEC-802, 803, 804, 805 *Input Current: 3A at 115VAC or 1.5A at 230VAC max. *Inrush Current: < 30A at 115VAC input or < 60A at 230VAC input at 25oC cold start Output PIN Output PIN *Load Range: With the +5V output set between 5.08~5.13V +5V 1 PWR On/Off 1~3 and all output at 60% rated load, while the other outputs are GND 2 GND 4~8 within the accuracy range; max. total combined output power 3 +5Vsb 9~10 +12V on the +3.3V and +5V rails is 70W, with the max. load not 11~13 +3.3V exceeding 120W 14 -12V *Ripple and Noise: Peak to peak ripple and noise is < 50mV for +5V and +3.3V outputs, 120mV for +5Vsb, < 120mV for Output Min. Rated Max. +12V, and 200mV for -12V at rated load and nominal input Tolerance Voltage Load Load Load *Line Regulation: < +/-1% for rated load with a +/-10% +5V 1A 8A 14A 4.9~5.1V change in input voltage +12V 0A 2.5A 6A 11.25~12.75V *Load Regulation: < +/-2% for +5V, < +7~-3% for +12V, -12V 0A 0.5A 1A -11.25~-13V +3.3V 0A 8A 12A 3.1~3.5V < +8~-3% for -12V, < +/-5% for +3.3V with measured output +5Vsb 0A 0.75A ---4.8~5.2V load changing within +/-40% and 60% rated load, while keeping other outputs at 60% rated load *Hold Up Time: > 16ms at 115VAC input and rated load *Power ON/OFF: Turns on power supply when power on/off pin is connected to secondary GND *Efficiency: > 70% at nominal line and rated load *Altitude: 10,000 feet *Protection: Hiccup mode against short circuit or over load conditions auto recovery when fault conditions are removed *Temperature: 0~+50oC, output power is 100W with 6CFM forced air, 120W with 18CFM forced air (operating); -40~+85oC (storage) *Connectors: AC Input: Molex 5273-05A withdraw 2-pin or equivalent device DC Output: TB2 is Molex 5273-14A or equivalent device; TB3 is Molex 5045-03A or equivalent device *Dimensions: 8.38 x 15.24 x 3.97 cm. Tolerance at +/-0.4mm www.boser.com.tw 0.25 1.5 6.85