OPI 2000MK High Speed Opto Isolator The OPI 2000MK High Speed Optically Coupled Isolator consists of a High Speed Infrared emitter coupled to a silicon photo I.C. The unit is designed for applications requiring high voltage isolation between input & output requirements. The Opto Logic sensor has a • metal screen connected to the ground lead for High Common mode rejection. 10KV isolation • High Speed 2Mb/sec. • Low Propagation Delay • OTHER COUPLERS IN THE SERIES:OPI2000M ATEX CERTIFIED SURFACE MOUNT OPI2000 AS THE OPI2000MK WITHOUT MASK MECHANICAL DATA +0.2 21.65 0 6.65 9.25 3.0 EMITTER +0.2 0 SENSOR 0.4 2.54 0.5 18.05 +0.2 0 An 2.54 K TOP VIEW 1.91 1.91 Gnd 1.91 Vout 1.91 UL APPROVED MATERIALS HOUSING E69578 LIGHTPIPE E67171(m) EPOXY E76072 Vcc BEDFORD OPTO TECHNOLOGY LTD 1,BIGGAR BUSINESS PARK, BIGGAR,LANARKSHIRE, ML12 6FX Tel: +44 (0) 1899 221221 Fax: +44 (0) 1899 221009 Website: bot.co.uk E-mail: [email protected] 9.4.03 ISS C OPI 2000MK ABSOLUTE MAXIMUM RATINGS (25OC unless otherwise noted) INPUT DIODE FORWARD DC CURRENT REVERSE DC VOLTAGE POWER DISSIPATION 100mA 5 Volts 150mW (ii) OUTPUT IC MAX SUPPLY VOLTAGE POWER DISSIPATION 7 Volts 165mW OPERATING TEMP -40OC TO +70OC STORAGE TEMP -40OC TO +85OC 260OC LEAD SOLDERING TEMP 2mm from body 5 secs max + 10KV DC (i) INPUT-TO-OUTPUT ISOLATION VOLTAGE i) Measured with the input leads and output leads shorted together for one min. ii) Thermal resistance 450 K/W Whilst the devices are capable of operating continually at the noted elevated temperatures users should be aware of the possibility of the need to increase the diode current to trigger the device over long periods at high temperatures & PARAMETER SYMBOL MIN TYP MAX UNITS TEST CONDITIONS Forward Voltage VF - 1.35 1.6 V If=100mA tp=20mS Reverse Voltage VR 5.0 - - V Ir = 100uA INPUT DIODE OUTPUT IC ( Vcc=4.75 to 5.25 ) High level Output Current ICH - 100 uA Ic = 10 uA Low Level Output Voltage VOL - 0.6 V IF=10mA IOL=2.6mA High Level Supply Current ICCH 15 mA IF=0 Low Level Supply Current ICCL 18 mA IF=10mA COUPLED(Vcc=5volts) Propagation Delay to Low Output tPHL 800 nSecs RL=560ohms C=0.01uF Propagation Delay to High Output tPLH 800 nSecs ditto CIRCUIT Vgen Rf GND + + RL =560 ohm RL C Vout Vcc C=0.01uF BEDFORD OPTO TECHNOLOGY LTD 1,BIGGAR BUSINESS PARK, BIGGAR,LANARKSHIRE, ML12 6FX Tel: +44 (0) 1899 221221 Fax: +44 (0) 1899 221009 Website: bot.co.uk E-mail: [email protected] 9..4.03 ISS C