LM309K Voltage Regulators GENERAL DESCRIPTION The LM309K is complete 5V regulator fabricated on a single silicon chip. The available output current is greater than 1A. He is designed for local regulation on digital logic cards, eliminating the distribution problems associated with single-point regulation. The devices are available in the TO3 power package. The regulators are essentially blow-out proof. Current limiting is included to limit the peak output current to a safe value. In addition, thermal shutdown is provided to keep the IC from overheating. If internal dissipation becomes too great, the regulator will shut down to prevent excessive heating. Considerable effort was expended to make these devices easy to use and minimize the number of external components. It is not necessary to bypass the output, although this does improve transient response somewhat. Input bypassing is needed, however, if the regulator is located very far from the filter capacitor of the power supply. Stability is also achieved by methods that provide very good rejection of load or line transients as are usually seen with TTL logic. Compliance to RoHS. ABSOLUTE MAXIMUM RATINGS Input Voltage Output Current Power Dissipation Operating Junction Temperature Range Storage Temperature Range 35V 1A Internally Limited 0° to 125°C -65° to 150°C CHARACTERISTICS (1) PARAMETER CONDITIONS MIN TYP MAX UNIT Output Voltage Tj = 25°C Tj = 25°C 7V ≤VIN ≤25V Tj =25°C 5mA ≤IOUT≤1.5A 7V ≤VIN ≤25V 5mA ≤IOUT ≤ IMAX P<PMAX 7V ≤VIN ≤25V 7V ≤VIN ≤25V 5mA ≤IOUT ≤ IMAX TA = 25°C 10HZ ≤ f ≤ 4.8 5.05 5.2 V - 4 50 mV - 50 100 mV 4.75 - 5.25 V - 5.2 10 mA - - 0.8 mA - 40 - mV - - 20 mV - 3 - °C/W Line Regulation Load Regulation Output Voltage Quiescent Current Quiescent Current Change Output Noise Voltage Long Term Stability Thermal Resistance Junction to case (2) (1) Tj = 0° to 125°C ; IOUT = 0.5A ;IMAX = 0.2A and PMAX = 2W ; IMAX = 1A and PMAX = 20W (2) Without a heat sink, the thermal resistance is approximately 35°C. With a heat sink, the effective thermal resistance can only approach the values specified, depending on the efficiency of the sink. COMSET SEMICONDUCTORS 1/2 LM309K MECHANICAL DATA CASE TO-3 DIMENSIONS A B C D E G H L M N P Pin 1 : Pin 2 : Case : mm 25,51 38,93 30,12 17,25 10,89 11,62 8,54 1,55 19,47 1 4,06 inches 1,004 1,53 1,18 0,68 0,43 0,46 0,34 0,6 0,77 0,04 0,16 Input Output GND COMSET SEMICONDUCTORS 2/2