CONNOR-WINFIELD OFA5BB1BA-20M

THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX
(630) 851-5040.
PHONE (630) 851-4722.
WWW.CONWIN.COM
PRODUCT
D ATA
SHEET
CRYSTAL CONTROLLED OSCILLATORS
SURFACE MOUNT 5.0V SINEWAVE OCXO
ABSOLUTE M AXIMUM RATING S
CW
0650
OFA5BB1BA
20MHZ
TABLE 1.0
PARAMETER
UNITS
MINIMUM
NOMINAL
MAXIMUM
-55
-
125
°C
Supply Voltage
(Vcc)
-0.5
-
7.0
Vdc
Control Voltage
(Vc)
-0.5
-
7.0
Vdc
Storage Temperature
UNITS
OPERATING SPECIFIC ATIONS
DESCRIPTION
TABLE 2.0
PARAMETER
MINIMUM
NOMINAL
MAXIMUM
UNITS
6.4
-
25
1.5
MHz
ppm
1, 4
-
-
0.25
ppm
2
-0.05
-
0.05
ppm
3
Aging (Daily
-30
-
30
ppb
4
Aging (20 years)
Total Frequency Tolerance
Operating Temperature Range
-2.5
-4.6
0
-
2.5
4.6
70
ppm
ppm
°C
5
Center Frequency
(Fo)
Frequency Calibration
-1.5
Frequency Stability
Frequency vs. Change in Supply Voltage
Supply Voltage
(Vcc)
4.75
5.00
5.25
Vdc
Supply Current
Steady State Supply Current @ 25°C
Phase Jitter (BW =10KHz to Fo/2)
Phase Jitter (BW =10Hz to Fo/2)
Period Jitter
Start-Up Time: Oscillator
Warm Up Time
TDEV at 1.0 seconds
TDEV at 4.0 seconds
(Icc)
-
150
-
300
1
3
3
35
5
1
2
mA
mA
ps RMS
ps RMS
ps RMS
ms
Minutes
ns
ns
SINEWAVE OUTPUT CHARACTERISTICS
NOTE
MINIMUM
45
0
NOMINAL
50
3
-60
-90
-120
MAXIMUM
55
-80
-
UNITS
Ohms
dBm
dBc
dBc/Hz
dBc/Hz
dBc/Hz
-
SSB Phase Noise at 1KHz offset
SSB Phase Noise at 10KHz offset
-
-140
-
dBc/Hz
-
-150
-
dBc/Hz
The Connor-Winfield
OFA5BB1BA is a true Surface
Mount 5.0V Oven Controlled
Crystal Oscillator (OCXO)
with a Sinewave output. The
OFA5BB1BA is designed for
applications requiring tight
frequency stability and low
jitter.
FEATURES
5.0V OPERATION
OCXO
6
SINEWAVE OUTPUT
LOW JITTER <1pS RMS
TABLE 3.0
PARAMETER
LOAD
Output Power
Spurious Output
SSB Phase Noise at 1Hz offset
SSB Phase Noise at 10Hz offset
SSB Phase Noise at 100Hz offset
OFA5BB1BA
NOTE
NOTE
TEMPERATURE STABILITY:
0.25ppm ABSOLUTE
TOTAL FREQUENCY TOLERANCE:
±4.6ppm OVER TWENTY YEARS
TEMPERATURE RANGE:
0 to 70C
SURFACE MOUNT PACKAGE
TAPE AND REEL PACKAGING
RoHS COMPLIANT / LEAD FREE
PACKAGE CHARACTERISTICS
Package
TABLE 4.0
Surface Mount, Non-hermetic package consisting of an FR4 substrate with
grounded metal cover.
PROCESS RECOMMENDATIONS
ORDERING INFORMATION
TABLE 5.0
Soldering Process
Wash
See solder profile page 2.
Ultrasonic cleaning is not recommended
OFA5BB1BA - 20 MHz
OCXO
SERIES
CENTER
FREQUENCY
Specifications subject to change without notice.
DATA SHEET #:
Cx119
PAGE 1
OF
2
REV: 00
DATE:
12/29/06
aCopyright 2001 Connor-Winfield all rights reserved.
THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX
(630) 851-5040.
PHONE (630) 851-4722.
WWW.CONWIN.COM
PRODUCT
D ATA
SHEET
CRYSTAL CONTROLLED OSCILLATORS
Notes:
1)
2)
3)
4)
5)
Initial calibration @ 25°C.
Frequency stability, absolute over the temperature range of 0 to 70 °C.
Frequency stability per 5% change in supply voltage.
At the time of shipment after 48 hour s of operation.
Inclusive of calibration, operating t emperature range, supply voltage change, shock and
vibration and aging (20 years).
6) Measured @ 25°C, within 5 minutes, the unit will be within +/-0.1ppm of its reference
frequency, measured after 30 m inutes of continuous operation at a st able 25°C.
PIN CONNECTIONS
TABLE 6.0
Pin
1
7
8
14
Function
N/C
Ground (Case)
Output
Vcc
ENVIRONMENTAL CHARACTERISTICS
Temperature Cycle: Per MIL-STD-883, Method 1010, Condition B. -55°C to 125°C, 300 cycles,
10 minute dwell, 1minute trans ition.
MECHANICAL CHARACTERISTICS
Vibration: Per MIL-STD-202, Method 204, Condition A . 10G’s peak, 10Hz to 500H z, 15 minute
cycles 12 times each perpendicu lar axis.
Shock: Per MIL-STD-202, Method 213, Condition F. 1 500G’s, 0.5ms, half sine, 3 shocks per
direction.
Moisture Resistance: Per MIL-STD-202, Method 106. 95% RH @ 65° C, 10 cycles 10°C to 65°C.
PACKAGE LAYOUT
SUGGESTED PAD LAYOUT
KEEP OUT AREA
CW DATE CODE
OFA5BB1BA
20MHZ
.330 max
(8.382mm)
.830
(21.08mm)
Dimensional Tolerance:
±.005 (.127mm)
.565
(14.35mm)
SOLDER PROFILE
TEST CIRCUIT
Temperature
260°C
260°C
220°C
180°C
POWER
SUPPLY
150°C
14
8
1
7
5.0Vdc
120°C
0
N/C
50 Ohm
Oscilloscope
Termination
120 S
Max.
Time
10 S
60 S
Max.
360 Sec. Max.
Specifications subject to change without notice.
DATA SHEET #:
Cx119
PAGE 2
OF
2
REV: 00
DATE:
12/29/06
aCopyright 2001 Connor-Winfield all rights reserved.