RDB105S SINGLE PHASE GLASS PASSIVATED FAST RECOVERY SURFACE MOUNT BRIDGE RECTIFIER VOLTAGE:600V CURRENT:1.0A DBS FEATURE For surface mount application Reliable low cost construction utilizing molded plastic Technique MECHANICAL DATA Terminal: Plated leads solderable per MIL-STD 202E, method 208C Case:UL-94 Class V-0 recognized Flame Retardant Epoxy Polarity: Polarity symbol marked on body Mounting position: any Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS (single-phase, half -wave, 60HZ, resistive or inductive load rating at 25°C, unless otherwise stated, for capacitive load, derate current by 20%) Vrrm Vrms Vdc RDB 105S 600 420 600 If(av) 1.0 A Ifsm 30.0 A Vf 1.3 V 10.0 500.0 250 25.0 -55 to +125 -55 to +150 µA mA SYMBOL Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC blocking Voltage Maximum Average Forward Rectified Current at Ta =40°C Peak Forward Surge Current 8.3ms single half sine-wave superimposed on rated load Maximum Instantaneous Forward Voltage at forward current 1.0A Maximum DC Reverse Current Ta =25°C at rated DC blocking voltage Ta =125°C Maximum Reverse Recovery Time (Note 1) Typical Junction Capacitance (Note 2) Operating Temperature Range Storage and Operating Junction Temperature Ir Trr Cj Tj Tstg Units V V V nS Pf °C °C Note: 1. Reverse Recovery Condition If =0.5A, Ir =1.0A, Irr =0.25A 2. Measured at 1.0 MHz and applied voltage of 4.0 volt Rev.A5 www.gulfsemi.com RATINGS AND CHARACTERISTIC CURVES RDB105S 1 1 Rev.A5 www.gulfsemi.com