HITRON HAM10S

H HiTRON
ON-BOARD UNIVERSAL INPUT AC-DC ENCAPSULATED MODULAR
POWER SUPPLIES 10 WATTS SINGLE & DUAL OUTPUT
HAM10S & HAM10D SERIES
FEATURES:
ON-BOARD AC/DC MODULAR
POWER SUPPLIES
UNIVERSAL AC INPUT RANGE
COMPACT IN SIZE
MEET UNIVERSAL SAFETY STANDARDS
EMI MEET CISPR PUB.22 / FCC CLASS B
CE MARKING COMPLIANCE
SPECIFICATION
INPUT SPECIFICATION
OUTPUT SPECIFICATION
Input Voltage: 90-264Vac typical. (or 110-340Vdc).
Input Frequency: 47-63 Hz. (50/60Hz.Nom.) or DC.
Input Current: 0.3A @115Vac./ 0.13A @ 230Vac.
Inrush Current: 32.5A peak @230Vac.
Input Fuse: Use external fuse. 1.0A/250Vac for
primary fuse is suggested.
Dielectric Withstand: Meet IEC950.
3,000Vac-Output/Input.
1,500Vac-Input/GND.
500Vac-Output/GND.
EMI: Meet CISPR PUB.22/ FCC Class B.
Hold-up time: 20mS @115Vac, 80mS @230Vac.
Earth Leakage: Less than 3.5mA @230Vac.
Output Voltage: See Ratings Chart.
Output Current: See Ratings Chart.
Output Wattage: 10 Watts typical.
Output Indicator: LED.
Line Regulation: Various with output voltage.
HAM10S ±0.1% typical.
HAM10D ±0.2% typical.
Load Regulation: Various with output voltage.
HAM10S ±1.0% typical.
HAM10D ±2.0% typical.
Noise & ripple: 1.0% typical peak to peak.
OVP: Built-in on main output.
Adjustability: From -10% of main output till OVP.
Overload Protection (OLP):
Fully protected against output overload and short circuit.
OLP set at about 125-150% rating output wattage.
Consult the factory for OLP setting.
GENERAL SPECIFICATION
Efficiency: 67-79% typical (Various with output voltage).
Switching Frequency: 75K Hz.
Circuit Topology: Fixed Frequency Flyback circuit.
Transient Response: Typical peak deviation 250mV,
Recovery time < 3mS for a 25% load change.
Case: Impact resistant thermo-plastic enclosure.
Weight: 120g (4.23 Oz).
Power Density: 2.51 Watts. / Cubic inch.
Safety Standard: EN60950/ UL1950 Class I.
MTBF: 100,000 hours. Mil Std 217, 25°C.
Operating Temperature: -10 to +70°C range.
-10°C to +50°C full load without derating.
From +50°C, derating linearly to half load @+70°C.
(Refer to Derating Chart.)
Storage Temperature: -20°C to +85°C.
Temperature Coefficient: ± 0.02% /°C.
Humidity: Up to 95%RH, Non-condensing.
Cooling: Convection cooling for +50°C @ full load.
At least 100LFM moving air is recommended
for full load > +50°C in a confined area.
Commercial Grade only.
NOTE: (1) All measurements are at nominal input, full load, and +25°C unless otherwise specified.
(2) Load Regulation measured from Full-Load (F-L) to Half-Load (H-L) at nominal input and others loaded at half load.
Due to requests in market and advances in technology, specifications subject to change without notice.
-3-
OUTPUT VOLTAGE/ CURRENT RATINGS CHART
SINGLE OUTPUT
MODEL NO.
HAM10S-033243
HAM10S-050200
HAM10S-090112
HAM10S-120090
HAM10S-150072
HAM10S-240045
HAM10S-480025
DUAL OUTPUT
VO1 @ ★
TYP.
2.43A
2.00A
1.12A
0.90A
0.72A
0.45A
0.25A
VOLT.
3.3V
5.0V
9.0V
12.0V
15.0V
24.0V
48.0V
PEAK
2.91A
2.44A
1.34A
1.08A
0.86A
0.54A
0.30A
MODEL NO.
HAM10D-033120
HAM10D-050100
HAM10D-120045
HAM10D-150035
+VO1 @ ★
TYP. VOLT.
1.20A +3.3V
1.00A +5.0V
0.45A +12.0V
0.35A +15.0V
MAX.
1.38A
1.15A
0.51A
0.40A
-VO2 ‖
TYP. VOLT. MAX.
1.20A -3.3V 1.38A
1.00A -5.0V 1.15A
0.45A -12.0V 0.51A
0.35A -15.0V 0.40A
Symbols: "★" OVP built-in. "@" Adjustable. "‖"Double Feedback.
Note: (1) Max. (maximum load) is the continuous operating load of each rail,
but the max. load of each rail can not be drawn from all outputs at the same time.
(2) Peak output, less than 60 Sec. with duty cycle <10%.
MECHANICAL DIMENSIONS: MM [INCHES]
WEIGHT: 120.0g (4.23 Oz.)
PIN ASSIGNMENT
PIN NO.
PIN #1.
PIN #2.
PIN #3.
PIN #4.
PIN #5.
PIN #6.
SINGLE
AC-GROUND
AC-NEUTRAL
AC-LINE
+ VO1
NO PIN
DC-COM
DERATING CHART
CASE SIZE: AM02
-4-
DUAL
AC-GROUND
AC-NEUTRAL
AC-LINE
+ VO1
DC-COM
-VO2