RF SAW Filter Part Number Package Application Last Modified 801-RF881.5M-D 2.5 x 2.0 SMD CDMA Mar. 2, 2007 . TYPE : CDMA, RF-Rx SAW Filter PART NUMBER : 801-RF881.5M-D .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 881.5 - MHz Maximum Insertion Loss 869.0~ 894.0 MHz - 2.4 2.8 dB Stop Band Attenuation: DC~ 840.0 MHz 45 51 - 840.0~851.0 MHz 40 45 - Center Frequency (Fo) 914.0~ 924.0MHz 20 26 - 924.0~ 950.0 MHz 34 39 - 950.0~ 997.0 MHz 40 49 - 997.0~ 2200.0 MHz 40 47 - dB 2200.0~ 3000.0 MHz 27 30 - Source Impedence (single ended)* - - 50 - Load Impendance (single ended)* - - 50 - ohm VSWR 869.0~ 894.0 MHz - 1.7 2.1 dBp-p Amplitude Ripple 869.0~ 894.0 MHz - 0.65 1.2 dBp-p Maximum DC Voltage - - - 5 V Maximum Input Power - - - 15 dBm Operating Temperature - -30 - +80 ºC ohm * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Out D Ground Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Part No.: 801-RF881.5M-D Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map