Oscilent Corporation RF SAW Filter | 862-RF1220.0M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 862-RF1220.0M-A 3.0 x 3.0 SMD Wireless Jan. 01, 2007 . TYPE : Wireless, Balanced RF SAW Filter PART NUMBER : 862-RF1220.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 1220.0 - MHz Maximum Insertion Loss 1216.0~ 1224.0 MHz - 3.5 4.8 dB Stop Band Attenuation: Fo-200.0~ Fo-68.0 MHz 46 51 - Fo-88.0 MHz 48 53 - Fo-72.0MHz 50 58 - Fo-44.0 MHz 48 56 - Center Frequency (Fo) Amplitude Ripple Source Impedence (balanced ended)* dB Fo-36.0 MHz 46 59 Fo-+70.0~ 2000.0 MHz 50 61 - 1216.0~ 1224.0 MHz - 0.4 1.0 dBp-p - - 200 - ohm - - 200 - ohm 1216.0~ 1224.0 MHz - 40 - nsp-p Maximum DC Voltage - - - 3 V Maximum Input Power - - - 0 dBm Operating Temperature - -30 - +80 ºC Load Impendance (balanced ended)* Group Delay Ripple * With Matching Network ns . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A In B In C Ground D Ground E Out F Out G Ground H Ground Oscilent Corporation RF SAW Filter | 862-RF1220.0M-A Load Impedance = 200 ohms Source Impedance = 200 ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 862-RF1220.0M-A Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 862-RF1220.0M-A