Oscilent Corporation RF SAW Filter | 862-RF1690.0M-B Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 862-RF1690.0M-B 3.0 x 3.0 SMD Wireless Jan. 01, 2007 . TYPE : Wireless, Balanced RF SAW Filter PART NUMBER : 862-RF1690.0M-B .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Attenuation: Condition Minimum Typical Maximum Units - - 1690.0 - MHz 1679.7~1698.8 MHz - 3.3 4.5 dB 54.0~1100.0 MHz 50 63 - dB 3262.7~3352.6 MHz 30 37 - dB 4911.0~5009.0 MHz 35 43 - dB 6559.4~6665.1 MHz 30 38 - dB 8211.1~8319.4 MHz 15 24 - dB Group Delay Ripple 1679.7~ 1698.8 MHz - 8.0 20.0 dB Input/ Output VSWR 1679.7~ 1698.8 MHz - 2.30 2.70 - Source Impedence (balanced ended)* - - 200 - ohm Load Impendance (balanced ended)* - - 200 - ohm Maximum DC Voltage - - - 3 V Maximum Input Power - - - 0 dBm Operating Temperature - -10 - +70 ºC * No Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A In B In C Ground D Ground E Out F Out G Ground H Ground Oscilent Corporation RF SAW Filter | 862-RF1690.0M-B Load Impedance = 200 ohms Source Impedance = 200 ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 862-RF1690.0M-B Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 862-RF1690.0M-B