Oscilent Corporation RF SAW Filter | 802-RF897.5M-A Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF897.5M-A 3.0 x 3.0 SMD EGSM Jan. 01 2007 . TYPE : EGSM, RF-Tx SAW Filter PART NUMBER : 802-RF897.5M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Amplitude Ripple Source Impedence (single ended)* Condition Minimum Typical Maximum Units - - 897.5 - MHz 880.0~ 915.0 MHz - 2.5 3.5 dB D.C.~ 840.0 MHz 17 23 - 840.0~860.0 MHz 17 29 - 860.0~ 865.0MHz 10 45 - 925.0~ 935.0 MHz 4.5 15 - dB 935.0~ 1850.0 MHz 20 24 1850.0~ 3660.0 MHz 10 15 - 880.0~ 915.0MHz - 1.2 2.0 dBp-p - - 50 - ohm ohm - - 50 - 880.0~ 915.0 MHz - 2.0 2.5 - Maximum DC Voltage - - - 3 V Maximum Input Power - - - 15 dBm Operating Temperature - -10 - +80 ºC Load Impendance (single ended)* VSWR * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Oscilent Corporation RF SAW Filter | 802-RF897.5M-A Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 802-RF897.5M-A Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF897.5M-A