Oscilent Corporation RF SAW Filter | 802-RF881.5M-B Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 802-RF881.5M-B 3.0 x 3.0 SMD CDMA Rx Apr. 12 2003 . TYPE : 881.5 MHz RF SAW Filter PART NUMBER : 802-RF881.5M-B . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Condition Minimum Typical Maximum Units - - 881.5 - MHz 869.0 ~ 894.0 MHz - 2.8 3.5 dB DC Voltage - - - 5 V Input Power - - - 15 dBm Operating Temperature - -30 - +65 °C Storage Temperature - -40 - +85 °C Center Frequency Insertion Loss Ripple Stopband Attenuation VSWR Teminating Impedance 869.0 ~ 894.0 MHz - 0.7 1.6 dB DC ~ 779MHz 50.0 57.0 - dB 779.0 ~ 849.0 MHz 45.0 49.0 - 914.0 ~ 970.0 MHz 28.0 33.0 - 970.0 ~ 1049.0 MHz 50.0 62.0 1049.0 ~ 2000.0 MHz 40.0 46.0 - 869.0 ~ 894.0 MHz - 1.7 2.0 - - - 50 - ohm * Maximum Rating (Ta=25°C) ** Custom SAW RF Filters available. Contact Oscilent for assistance. . Pin Layout A Ground B Output C Ground D Ground E Input F Ground Frequency Reponse http://www.oscilent.com/spec_pages/rf_sawfilter/rf_802_rf881_5b.htm 12/28/2005 Oscilent Corporation RF SAW Filter | 802-RF881.5M-B Page 2 of 2 VSWR (S11, S22) Smith Chart Oscilent Corporation - CALL 949.252.0522 17962 Sky Park Circle . Building D . Irvine . CA 92614 . USA Fax: 949.252.0599 . E-Mail: [email protected] Part No.: 802-RF881.5M-B Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/rf_sawfilter/rf_802_rf881_5b.htm 12/28/2005