Oscilent Corporation IF SAW Filter | 805-IF360.0M-D Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 805-IF360.0M-D 5.0 x 5.0 SMD Mobile Communication Jul. 03, 2007 . TYPE : IF Filter for GSM, PCN system PART NUMBER : 805-IF360.0M-D .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units - - 360 - MHz - - 4.6 5.2 dB Fo ± 0.4 ~ Fo ± 0.6 MHz 35 38 - Fo ± 0.6 ~ Fo ± 0.8 MHz 42 50 - Fo ± 0.8 ~ Fo ± 1.6 MHz 42 55 - Fo ± 1.6 ~ Fo ± 5.0MHz 45 55 - Fo ± 5.0 ~ Fo ± 30.0 MHz Center Frequency (Fo) Insertion Loss (a min.) Relative Attenutation dB 50 57 - Amplitude Ripple Fo ± 67.7 KHz - 0.8 1.5 Group Delay Ripple Fo ± 67.7 KHz - 0.7 2.0 us dB FTC - - 0.032 - ppm/ºC² Terminating Impedance - - 50 - ohm DC Voltage - - 0 - V Input Power - - 5 - dBm Operating Temperature - 0 - +55 ºC Storage Temperature - -35 - +85 ºC * Maximum Rating (Ta = 25ºC) ** Custom SAW IF Filters available. Contact Oscilent for assistance. PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A In B In or Ground C Ground D Ground E Out F Out or Ground G Ground H Ground Oscilent Corporation IF SAW Filter | 805-IF360.0M-D L1 = 68nH C1 = 7pF L2 = 74nH C2 = 7pF Source/Load Impedance = 50 ohms L1 = 56nH C1 = 5pF L2 = 56nH C2 = 4.3pF L3 = 56nH L4 = 56nH Source/Load Impedance = 50 ohms FREQUENCY RESPONSE Page 2 of 3 Oscilent Corporation IF SAW Filter | 805-IF360.0M-D Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 805-IF360.0M-D