Oscilent Corporation RF SAW Filter | 863-RF315.0M-A Page 1 of 2 RF SAW Filter Part Number Package Application Last Modified 863-RF315.0M-A 3.8 x 3.8 SMD Remote Control Jan. 01, 2007 . TYPE : Remote Control, RF SAW Filter PART NUMBER : 863-RF315.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss (IL MIN) Stop Band Attenuation: Condition Minimum Typical Maximum Units - - 315.0 - MHz 314.82 ~ 315.22 MHz - 2.2 4.0 dB 10.0 ~ 270.0 MHz 45 50 - 270.0~ 309.0 MHz 30 35 - 309.0 ~ 313.94 MHz 15 20 - 316.0 ~ 335.0 MHz 10 15 - dB 335.0 ~ 400.0 MHz 35 40 400.0 ~ 1000.0 MHz 45 50 - 314.77 ~315.2 MHz - 1.5 3.0 314.77 ~315.26 MHz - 2.0 6.0 3dB Passband Width relative to IL MIN - 0.8 0.92 - MHz Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm 433.76~ 434.16 MHz - 1.0 2.0 - Pass Band Relative to IL MIN Pass Band Ripple dB Maximum Input Power - - - 10 dBm Operating Temperature - -40 - +125 ºC * With Matching Network . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE 1 Out 2 Ground 3 Ground 4 Ground 5 In 6 Ground 7 Ground 8 Ground Oscilent Corporation RF SAW Filter | 863-RF315.0M-A Page 2 of 2 Source/ Load Impedance = 50 ohms FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 863-RF315.0M-A