Oscilent Corporation IF SAW Filter | 863-RF243.95M-A Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 863-RF243.95M-A 3.8 x 3.8 SMD PHS Jan. 01 2007 . TYPE : PHS, IF SAW Filter PART NUMBER : 863-RF243.95M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units - - 243.95 - MHz - - 3.0 4.0 dB Fo ± 600 MHz 25 30 - Fo ± 10.7 MHz 40 60 - Fo ± 21.4 MHz 60 65 - Center Frequency (Fo) Insertion Loss Relative Attenutation dB Source Impedence (single ended)* - - 50 - ohm Amplitude Ripple within Fo ± 100KHz - 0.4 1.0 dB Group Delay Ripple within Fo ± 100KHz - 0.4 1.0 us Load Impendance (single ended)* - - 50 - ohm Terminating Impedance - - 50 - ohm DC Voltage - - - 0 V Input Power - - 0 5 dBm Operating Temperature - -10 - +60 ºC * With matching network (Ref. Testing Environment Circuit as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B In C Ground D Ground E Out F Ground G Out H Ground Oscilent Corporation IF SAW Filter | 863-RF243.95M-A Source/Load Impedance = 50 ohms FREQUENCY RESPONSE Page 2 of 3 Oscilent Corporation IF SAW Filter | 863-RF243.95M-A Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 863-RF243.95M-A