Preliminary PLL502-22 384MHz – 768MHz Low Phase Noise LVDS VCXO (12 – 24MHz Crystal) FEATURES • • • • • Low phase noise output for the 384MHz to 768MHz range (-130 dBc at 10kHz offset). LVDS output. 12 to 24MHz crystal input. Integrated crystal load capacitor: no external load capacitor required. Output Enable selector. Wide pull range (+/-180 ppm) 3.3V operation. Available in 16 Pin TSSOP or SOIC. DESCRIPTION The PLL502-22 is a monolithic low jitter and low phase noise (-130dBc/Hz @ 10kHz offset) VCXO IC with LVDS output, for 384MHz to 768MHz output range. It allows the control of the output frequency with an input voltage (VIN), using a low cost crystal. The chip provides a pullable output at a frequency of F XIN x 32. This makes the PLL502-22 ideal for a wide range of applications, including 622.08MHz for SONET. VDD 1 16 VDD VDD 2 15 GND_BUF XIN 3 14 CLKBAR XOUT 4 13 VDD_BUF OE 5 12 CLK VIN 6 11 GND_BUF GND 7 10 GND GND 8 9 GND PLL 502-22 • • • PIN CONFIGURATION F OUT = F XIN x 32 OE (Pin 5) 0 1 (Default) Output State Tri-state Output enabled BLOCK DIAGRAM VCO Divider Reference Divider XIN XOUT XTAL OSC Phase Comparator Charge Pump Loop Filter VCO CLKBAR CLK OE VARICAP VIN 47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991 Rev 07/17/01 Page 1 Preliminary PLL502-22 384MHz – 768MHz Low Phase Noise LVDS VCXO (12 – 24MHz Crystal) PIN DESCRIPTIONS Name Number Type Description VDD 1,2,16 P +3.3V Power supply connectors. XIN 3 I Crystal input pin. XOUT 4 I Crystal output pin. OE 5 I Output enable input pin. Disables (tri-state) output when low. Internal pull-up enables output by default if pin is not connected to low. VIN 6 I Frequency control voltage input pin. GND 7,8,9,10 P GND Power connectors. GND_BUF 11,15 P GND connector for output buffers. CLK 12 O True clock output pin. VDD_BUF 13 P +3.3V Power supply connector for output buffers. CLKB 14 O Complementary clock output pin. ELECTRICAL SPECIFICATIONS 1. Absolute Maximum Ratings PARAMETERS Supply Voltage SYMBOL MIN. V DD MAX. UNITS 7 V Input Voltage, dc VI V SS - 0.5 V DD + 0.5 V Output Voltage, dc VO V SS - 0.5 V DD + 0.5 V Storage Temperature TS -65 150 °C Ambient Operating Temperature TA 0 70 °C Junction Temperature TJ 125 °C 260 °C 2 kV Lead Temperature (soldering, 10s) Input Static Discharge Voltage Protection Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other conditions above the operational limits noted in this specification is not implied. 47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991 Rev 07/17/01 Page 2 Preliminary PLL502-22 384MHz – 768MHz Low Phase Noise LVDS VCXO (12 – 24MHz Crystal) 2. Crystal Specifications PARAMETERS SYMBOL Crystal Resonator Frequency Crystal Loading Rating Crystal Pullability CONDITIONS MIN. Parallel Fundamental Mode F XIN TYP. 12 MAX. UNITS 24 MHz TBD C L (xtal) pF C 0 /C 1 (xtal) AT cut 250 - RE AT cut 30 Ω Recommended ESR 3. Voltage Control Crystal Oscillator PARAMETERS VCXO Stabilization Time * SYMBOL T VCXOSTB Output Frequency Synthesis Error CONDITIONS MIN. From power valid TYP. 10 (Unless otherwise noted in Frequency Table) F XIN = 12 - 24MHz; VCXO Tuning Range XTAL C 0 /C 1 < 250 CLK output pullability 0V ≤ VCON ≤ 3.3V MAX. UNITS ms ±30 ppm 380 ppm ±190 ppm Linearity 5 VCXO Tuning Characteristic 10 115 % ppm/V Note: Parameters denoted with an asterisk (*) represent nominal characterization data and are not production tested to any specific limits. 4. General Electrical Specifications PARAMETERS SYMBOL Supply Current, Dynamic (with Loaded Outputs) I DD Operating Voltage V DD Output Clock Duty Cycle CONDITIONS MIN. TYP. LVDS 3.13 @ 1.25V (LVDS) Short Circuit Current 47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991 45 50 ±50 MAX. UNITS 60 mA 3.47 V 55 % mA Rev 07/17/01 Page 3 Preliminary PLL502-22 384MHz – 768MHz Low Phase Noise LVDS VCXO (12 – 24MHz Crystal) 5. Jitter and Phase Noise specification PARAMETERS CONDITIONS Phase Noise relative to carrier With capacitive decoupling between VDD and GND. With capacitive decoupling between VDD and GND. Over 10,000 cycles. 622MHz @100Hz offset Phase Noise relative to carrier Period jitter RMS MIN. TYP. MAX. UNITS 7 ps 11 ps -80 dBc/Hz 622MHz @1kHz offset -109 dBc/Hz Phase Noise relative to carrier 622MHz @10kHz offset -130 dBc/Hz Phase Noise relative to carrier 622MHz @100kHz offset -132 dBc/Hz Accumulated jitter RMS 6. LVDS Electrical Characteristics PARAMETERS Output Differential Voltage V DD Magnitude Change SYMBOL MIN. TYP. MAX. UNITS V OD 247 355 454 mV ∆V OD -50 50 mV 1.6 V Output High Voltage V OH Output Low Voltage V OL Offset Voltage CONDITIONS 1.4 R L = 100 Ω (see figure) 0.9 1.1 V OS 1.125 1.2 1.375 V Offset Magnitude Change ∆V OS 0 3 25 mV Power-off Leakage I OXD ±1 ±10 uA Output Short Circuit Current I OSD -5.7 -8 mA V out = V DD or GND V DD = 0V 47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991 V Rev 07/17/01 Page 4 Preliminary PLL502-22 384MHz – 768MHz Low Phase Noise LVDS VCXO (12 – 24MHz Crystal) 7. LVDS Switching Characteristics PARAMETERS SYMBOL CONDITIONS MIN. TYP. MAX. UNITS Differential Clock Rise Time tr 0.2 0.7 1.0 ns Differential Clock Fall Time tf R L = 100 Ω C L = 10 pF (see figure) 0.2 0.7 1.0 ns LVDS Levels Test Circuit LVDS Switching Test Circuit OUT OUT CL = 10pF 50Ω VOD VOS VDIFF RL = 100Ω 50Ω CL = 10pF OUT OUT LVDS Transistion Time Waveform OUT 0V (Differential) OUT 80% V DIFF 80% 0V 20% 20% tR tF 47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991 Rev 07/17/01 Page 5 Preliminary PLL502-22 384MHz – 768MHz Low Phase Noise LVDS VCXO (12 – 24MHz Crystal) PACKAGE INFORMATION 16 PIN Narrow SOIC, TSSOP ( mm ) SOIC TSSOP Symbol Min. Max. Min. Max. A 1.35 1.75 - 1.20 A1 0.10 0.25 0.05 0.15 B 0.33 0.51 0.19 0.30 C 0.19 0.25 0.09 0.20 D 9.80 10.00 4.90 5.10 E 3.80 4.00 4.30 H 5.80 6.20 L 0.40 e E H D 4.50 6.40 BSC 1.27 0.45 1.27 BSC 0.75 A A1 C 0.65 BSC L B e ORDERING INFORMATION For part ordering, please contact our Sales Department: 47745 Fremont Blvd., Fremont, CA 94538, USA Tel: (510) 492-0990 Fax: (510) 492-0991 PART NUMBER The order number for this device is a combination of the following: Device number, Package type and Operating temperature range PLL502-22 S C XX PART NUMBER REVISION CODE (when applicable) TEMPERATURATURE C=COMMERCIAL M=MILITARY I=INDUSTRAL PACKAGE TYPE S=SOIC, O=TSSOP PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information furnished by Phaselink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product. LIFE SUPPORT POLICY: PhaseLink’s products are not authorized for use as critical components in life support devices or systems without the express written approval of the President of PhaseLink Corporation. 47745 Fremont Blvd., Fremont, California 94538 TEL (510) 492-0990 FAX (510) 492-0991 Rev 07/17/01 Page 6