RSG PSP-1500

RSG
RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany
Tel. +49 69 984047-0 Fax +49 69 984047-77 [email protected] www.rsg-electronic.de
■
■
ELECTRONIC COMPONENTS
■
■
■
Änderungen vorbehalten / subject to change without notice
1500W Single Output with PFC Function
■
PSP-1500
series
Features :
AC input active surge current limiting
Built-in active PFC function
Protections:Short circuit/Over load/Over voltage/Over temperature
Built-in constant current limiting circuit
Built-in remote ON-OFF control
Built-in remote sense function
3 years warranty
SPECIFICATION
MODEL
PSP-1500-5
PSP-1500-12
PSP-1500-13.5
PSP-1500-15
PSP-1500-24
PSP-1500-27
PSP-1500-48
DC VOLTAGE
5V
12V
13.5V
15V
24V
27V
48V
RATED CURRENT
217.5A
112.5A
100.5A
90A
56.4A
50.4A
28.5A
CURRENT RANGE
0 ~ 217.5A
0 ~ 112.5A
0 ~ 100.5A
0 ~ 90A
0 ~ 56.4A
0 ~ 50.4A
0 ~ 28.5A
RATED POWER
1087.5W
1350W
1356.75W
1350W
1353.6W
1360.8W
1368W
1500W
1500W
1500W
1500W
1500W
1500W
150mVp-p
150mVp-p
150mVp-p
150mVp-p
200mVp-p
12 ~ 15V
2.0%
0.3%
0.5%
13.5 ~ 18V
2.0%
0.3%
0.5%
20 ~ 26.4V
1.0%
0.2%
0.5%
24 ~ 30V
1.0%
0.2%
0.5%
41 ~ 56V
1.0%
0.2%
0.5%
84%
84%
85%
85%
86%
PEAK LOAD
OUTPUT
Note.4 1200W
150mVp-p
RIPPLE & NOISE (max.) Note.2 100mVp-p
VOLTAGE ADJ. RANGE
4.75 ~ 5.5V
10 ~ 13.2V
3.0%
6.0%
VOLTAGE TOLERANCE Note.3
0.3%
0.5%
LINE REGULATION
0.5%
2.0%
LOAD REGULATION
1500ms, 50ms/230VAC at full load
SETUP, RISE TIME
HOLD TIME (Typ.)
INPUT
176 ~ 264VAC
FREQUENCY RANGE
47 ~ 63Hz
POWER FACTOR (Typ.)
0.96/230VAC at full load
EFFICIENCY (Typ.)
77%
AC CURRENT (Typ.)
INRUSH CURRENT (Typ.)
8.4A/230VAC
80A/230VAC
LEAKAGE CURRENT
OVER LOAD
PROTECTION OVER VOLTAGE
248 ~ 370VDC
84%
<3.5mA / 240VAC
115 ~ 140% rated output power
Protection type : Constant current limiting, recovers automatically after fault condition is removed
5.75 ~ 6.75V
13.8 ~ 16.2V
15.5 ~ 18.2V
18 ~ 21V
27.6 ~ 32.4V
31 ~ 36.5V
Protection type : Shut down o/p voltage, re-power on to recover
WORKING TEMP.
95 (TSW1) Detect on the heatsink of PFC MOSFET
90 (TSW2) Detect the winding of output choke
Protection type : Shut down o/p voltage, recovers automatically after temperature goes down
RC+/RC-: 0 ~ 0.8V=power on ; 4 ~ 10V=power off
sink current <30mA
-10 ~ +60 (Refer to output load derating curve)
WORKING HUMIDITY
20 ~ 90% RH non-condensing
OVER TEMPERATURE
FUNCTION
24ms/230VAC at full load
VOLTAGE RANGE
REMOTE CONTROL
ENVIRONMENT STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
-20 ~ +85
57.6 ~ 67.2V
, 10 ~ 95% RH
VIBRATION
SAFETY STANDARDS
0.03%/ (0 ~ 50
10 ~ 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes
UL60950-1, TUV EN60950-1 Approved
WITHSTAND VOLTAGE
I/P-O/P:3KVAC
I/P-FG:1.5KVAC
O/P-FG:0.5KVAC
SAFETY & ISOLATION RESISTANCE
EMC
(Note 5)
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC
EMI CONDUCTION & RADIATION Compliance to EN55022 (CISPR22) Class B
Compliance to EN61000-3-2,-3
HARMONIC CURRENT
EMS IMMUNITY
MTBF
OTHERS
DIMENSION
PACKING
NOTE
Compliance to EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, Light industry level, criteria A
43.4K hrs min. MIL-HDBK-217F (25
278*129*190.5mm (L*W*H)
7.4Kg; 2pcs/15.5Kg/1.28CUFT
)
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. 10% Duty cycle maximum within every 30 seconds(max.). Average output power should not exceed the rated power.
5. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets
EMC directives.
File Name:PSP-1500-SPEC 2006-04-13
PSP-1500
1500W Single Output with PFC Function
Mechanical Specification
Unit:mm
127
Case No. 925A
series
31.75
4-M4
52
200
CONTROL
O/P
6-M6
2
4
6
1
3
5
8
38
8
7
6
5
47.5
6-M3
Air flow
direction
4
3
2
1
129
39
113
83
ADJ LED
32
24.75
240
63.5
185
63.5
190.5
190.5
I/P
127
7
10
3
2
1
31.75
4-M4
200
278
52
AC Input Terminal Pin. No Assignment
DC Output Terminal Pin. No Assignment
Pin No. Assignment
Pin No.
1,3,5
2,4,6
AC/L
AC/N
FG
1
2
3
Control Pin. No Assignment : MOLEX 5559-NP uses 5558male crimp terminal
Pin No.
1
2
Assignment
DC OUTPUT +V
DC OUTPUT -V
3
4
Assignment
NC
-S
G
RC-
Pin No.
5
6
7
8
Assignment Mating connector
Terminal
NC
MOLEX 5556
NC
MOLEX 5557-NR Female crimp
Terminal
+S
receptacle
RC+
Output Derating VS Input Voltage
Derating Curve
12 ~ 48V
100
100
90
80
80
5V
70
LOAD(%)
LOAD (%)
60
40
20
-10
0
10
20
30
40
50
AMBIENT TEMPERATURE (
RSG
60
70 (HORIZONTAL)
ELECTRONIC COMPONENTS
50
40
176
264
)
INPUT VOLTAGE (V) 60Hz
RSG Electronic Components GmbH Sprendlinger Landstr. 115 D-63069 Offenbach/Germany
File Name:PSP-1500-SPEC
Tel. +49 69 984047-0 Fax +49 69 984047-77 [email protected] www.rsg-electronic.de
■
■
60
■
Änderungen vorbehalten / subject to change without notice
■
■
■
2006-04-13