Model 100200-4Z50-2 Surface Mount Termination 10 Watts, 50Ω Description The 100200-4Z50-2 is high performance Alumina surface mount termination intended as a lower cost alternative to Aluminum Nitride (AlN) and Beryllium Oxide (BeO). The termination is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for terminating 90 degree hybrid, directional couplers, and for use in isolators. General Specifications Features: • 10 Watts • Lowest Cost • True Surface Mount • BeO Ceramic Resistive Element Substrate Terminal Finish Operating Temperature Thick film BeO Ceramic Thick film Silver -55 to +125°C (see chart) Tolerance is ±0.010”, unless otherwise specified. Designed to meet of exceed applicable portions of MIL-E-5400. All dimensions in inches. Electrical Specifications • Low VSWR Resistance Value: Power: Frequency Range: V.S.W.R.: • 100% Tested Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change without notice • Non-Nichrome Resistive Element 50 ohms, ± 2% 10 Watts DC – 3.0 GHz 1.25:1 Outline Drawing 100200-4Z50-2 (097) Rev B pg. 1 of 2 Available on Tape and Reel For Pick and Place Manufacturing. USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model 100200-4Z50-2 Typical Performance: Power De-rating: Tape & Reel: PCB Solder interface Temperature - °C Mounting Footprint and Procedure: 50 ohm line SCREW (2 PLS.) 0.092 [2.34] 0.025 [0.63] SOLDER PASTE 0.035 [0.89] Ø0.101 [Ø2.57] 2x 4-40 Screw Hole Ø0.031 [Ø0.79] 0.060 [1.52] PC BOARD HEATSINK SOLDER FILLED VIA MOUNTING PROCEDURE 0.250 [6.35] 1. Drill thermal vias through PCB and fill with solder. Dimension given in inches [millimeters] For best thermal performance the PCB should be soldered to the heat sink. 2. Solder part in place using appropriate solder with a controlled temperature iron. 3. To ensure good thermal connectivity to heat sink, which is critical for proper operation, drill and tap heatsink and mount PCB board to heatsink using screws. 100200-4Z50-2 (097) Rev B pg. 2 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Available on Tape and Reel For Pick and Place Manufacturing.