3.5x2.8 mm SMD CHIP LED LAMP ATTENTION AA3528MBC BLUE OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DISCHARGE SENSITIVE DEVICES Description Features The Blue source color devices are made with GaN on SiC SINGLE COLOR. SUITABLE FOR ALL SMT ASSEMBLY AND SOLDER Light Emitting Diode. Static electricity and surge damage the LEDS. PROCESS. It is recommended to use a wrist band or AVAILABLE ON TAPE AND REEL. anti-electrostatic glove when handling the LEDs. IDEAL FOR BACKLIGHTING. All devices, equipment and machinery must be electrically PACKAGE : 1500PCS / REEL. grounded. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3.Specifications are subject to change without notice. SPEC NO: DSAC1879 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: Y.CENG PAGE: 1 OF 4 ERP: 1201000302 Selection Guide Part No. Dice AA3528MBC Iv (mcd) @ 20mA Lens Type BLUE (GaN) Viewing Angle Min. Typ. 2θ θ1/2 4 15 120° WATER CLEAR Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Blue λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 430 nm IF=20mA Blue 466 nm IF=20mA Spectral Line Half-width Blue 60 nm IF=20mA C Capacitance Blue 100 pF VF=0V;f=1MHz VF Forward Voltage Blue 3.8 4.5 V IF=20mA IR Reverse Current Blue 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Blue Units Power dissipation 135 mW DC Forward Current 30 mA Peak Forward Current [1] 150 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAC1879 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: Y.CENG PAGE: 2 OF 4 ERP: 1201000302 Blue SPEC NO: DSAC1879 APPROVED: J. Lu AA3528MBC REV NO: V.2 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: Y.CENG PAGE: 3 OF 4 ERP: 1201000302 AA3528MBC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAC1879 APPROVED: J. Lu REV NO: V.2 CHECKED: Allen Liu DATE: MAR/09/2005 DRAWN: Y.CENG PAGE: 4 OF 4 ERP: 1201000302