SUBMINIATURE SOLID STATE LAMP AM27EC08 HIGH EFFICIENCY RED Features OSUBMINIATURE PACKAGE. Description OWIDE VIEWING ANGLE. The High Efficiency Red source color devices are made with OYOKE LEAD. Gallium Arsenide Phosphide on Gallium Phosphide Orange OLONG LIFE-SOLID STATE RELIABILITY. Light Emitting Diode. OLOW PACKAGE PROFILE. OPACKAGE : 1000PCS / REEL. ORoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1309 REV NO: V.2 DATE: MAR/09/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000246 Selection Guide Part No. Dice AM27EC08 Iv (mcd) @ 20 mA Lens Type HIGH EFFICIENCY RED (GaAsP/GaP) WATER CLEAR Viewing Angle Min. Typ. 2 θ 1/2 10 70 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength High Efficiency Red λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 627 nm IF=20mA High Efficiency Red 625 nm IF=20mA Spectral Line Half-width High Efficiency Red 45 nm IF=20mA C Capacitance High Efficiency Red 15 pF VF=0V;f=1MHz VF Forward Voltage High Efficiency Red 2.0 2.5 V IF=20mA IR Reverse Current High Efficiency Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter High Efficiency Red Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 160 mA 5 V Reverse Voltage -40°C To +85°C Operating/Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1309 REV NO: V.2 DATE: MAR/09/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000246 High Efficiency Red AM27EC08 SPEC NO: DSAD1309 REV NO: V.2 DATE: MAR/09/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000246 AM27EC08 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD1309 REV NO: V.2 DATE: MAR/09/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000246