T-1 3/4 (5mm) ROUND LED LAMP PRELIMINARY SPEC WP2523SURC/E Features Description OOUTSTANDING MATERIAL EFFICIENCY. The Hyper Red source color devices are made with DH ORELIABLE AND RUGGED. HYPER RED InGaAlP on GaAs substrate Light Emitting Diode. OI.C. COMPATIBLE. O RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2455 REV NO: V.1 DATE: APR/19/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1101002944 Selection Guide Part No. Dice WP2523SURC/E Iv (mcd) @ 20mA Lens Type HYPER RED (InGaAlP) WATER CLEAR Viewing Angle Min. Typ. 2θ1/2 1500 4500 12° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Hyper Red λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 640 nm IF=20mA Hyper Red 630 nm IF=20mA Spectral Line Half-width Hyper Red 25 nm IF=20mA C Capacitance Hyper Red 45 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.9 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Hyper Red Units Power dissipation 150 mW DC Forward Current 30 mA Peak Forward Current [1] 200 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2455 REV NO: V.1 DATE: APR/19/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1101002944 Hyper Red WP2523SURC/E SPEC NO: DSAF2455 REV NO: V.1 DATE: APR/19/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1101002944 PACKING & LABEL SPECIFICATIONS WP2523SURC/E Remarks: If special sorting is required (e.g. binning based on forward voltage, luminous intensity, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous Intensity: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2455 REV NO: V.1 DATE: APR/19/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1101002944