T-1 (3mm) INFRA-RED EMITTING DIODE WP34SF6BT Features Description MECHANICALLY AND SPECTRALLY MATCHED TO THE WP32P3C PHOTOTRANSISTOR. SF6 Made with Gallium Aluminum Arsenide Infrared Emitting diodes. BLUE TRANSPARENT LENS. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the leads emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAF2290 REV NO: V.1 DATE: APR/16/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101003573 Selection Guide Part No. Dice WP34SF6BT GaAlAs Po (mW/sr) @ 20 mA*50mA Lens Type Viewing Angle Min. Typ. 2θ θ1/2 7 15 50° *10 *40 50° BLUE TRANSPARENT Notes: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. 2. * Luminous intensity with asterisk is measured at 50mA. Electrical / Optical Characteristics at TA=25°C Item P/N Symbol Typ. Max. Units Condition Forward Voltage SF6 VF 1.35 1.6 V IF=20mA Reverse Current SF6 IR - 10 uA VR=5V Junction Capacitance SF6 C 30 - pF VF=0V;f=1MHz Peak Spectral Wavelength SF6 λP 860 - nm IF=20mA Spectral Bandwidth SF6 ∆λ1/2 50 - nm IF=20mA Absolute Maximum Ratings at TA=25°C Item Symbol SF6 Units Power dissipation PT 100 mW Forward Current IF 50 mA Peak Forward Current [1] iFS 1 A VR 5 V Reverse Voltage Operating Temperature Topr -40°C To +85°C Storage Temperature Tstg -40°C To +85°C Lead Solder Temperature [2] 260°C For 3 Seconds Lead Solder Temperature [3] 260°C For 5 Seconds Notes: 1. 1/100 Duty Cycle, 10us Pulse Width. 2. 2mm below package base. 3. 5mm below package base. SPEC NO: DSAF2290 REV NO: V.1 DATE: APR/16/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101003573 WP34SF6BT SPEC NO: DSAF2290 REV NO: V.1 DATE: APR/16/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101003573 PACKING & LABEL SPECIFICATIONS WP34SF6BT Remarks: If special sorting is required (e.g. binning based on forward voltage or radiant intensity), the typical accuracy of the sorting process is as follows: 1. Radiant Intensity: +/-15% 2. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAF2290 REV NO: V.1 DATE: APR/16/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.W.WANG ERP:1101003573