Current Transducer FA-050..100PV IPN DC = 50 .. 100 A For the electronic measurement of currents: DC, AC, pulsed, mixed, with a galvanic isolation between the primary circuit (high power) and the secondary circuit (electronic circuit). Electrical data Primary continuous direct current (nominal) IPN DC (A) 50 100 VOUT IC VC Vd Primary current, measuring range IPM (A) 0 .. ± 70 0 .. ± 130 Type RoHS since date code FA-050PV 50A-4V FA-100PV 100A-4V Output voltage (Analog) @ ± IPN DC, RL = 10kΩ, TA = 25°C Current consumption FA-050PV FA-100PV Supply voltage (± 5 %) Rms voltage for AC isolation test, 50 Hz, 1min • Galvanic isolation between primary V 16 mA ± IPN DC/ 1000A 16 mA ± IPN DC/ 2000A ± 15 2.5 • Closed loop (compensation) current transducer using the Hall effect planned 46209 ±4 Features and secondary circuit • Isolation voltage 2500 V~ • Compact design for PCB mounting • Low power consumption V kV Advantages Accuracy-Dynamic performance data X ε L VOE VOH TCVOE TCVOUT tr Accuracy @ TA = 25°C, + 15 V (+ 5 %) Linearity error (0 .. ± IPN DC) Electrical offset voltage @ IP = 0, @ TA = 25°C Hysteresis offset voltage @ IP = 0; after an excursion of 1 x IPN DC Temperature coefficient of VOE Temperature coefficient of VOUT (% of reading) Response time to 90% of IPN DC step < ± 1.5 % of IPN DC < ± 0.25% of IPN DC < ± 0.016 V < ± 0.012 V < ± 0.4 mV/K < ± 0.04 %/K <1 µs Ambient operating temperature Ambient storage temperature Mass ratings range • High immunity to external interference. Applications • Static converters for DC motor drives • Switched Mode Power Supplies General data TA TS m • Easy mounting • Small size and space saving • Only one design for wide current - 10 .. + 70 - 15 .. + 80 25 °C °C g (SMPS) • AC variable speed drives and servo motor drives • Uninterruptible Power Supplies (UPS) • Battery supplied applications • Power supplies for welding applications Application domain • Industrial Page 1/2 061030/2 LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice. www.lem.com Dimensions FA-050..100PV (in mm. 1 mm = 0.0394 inch) Terminal Pin dentification Safety This transducer must be used in electric/electronic equipment with respect to applicable standards and safety requirements in accordance with the following manufacturer's operating instructions. Caution, risk of electrical shock When operating the transducer, certain parts of the module can carry hazardous voltage (eg. primary busbar, power supply). Ignoring this warning can lead to injury and/or cause serious damage. This transducer is a built-in device, whose conducting parts must be inaccessible after installation. A protective housing or additional shield could be used. Main supply must be able to be disconnected. Page 2/2 061030/2 LEM reserves the right to carry out modifications on its transducers, in order to improve them, without prior notice. www.lem.com