Series AMER90-AZ up to 3.75A | AC-DC / DC-DC | LED Driver / Converter FEATURES: AC-DC Constant Current or Constant Voltage LED Driver Input range 90-305VAC/47-440Hz High Efficiency up to 91% Operating temperature -40 to 85°C Dimmable via analog / 0-10V dimming ② Models Single output Over Temperature Protection Over Current Protection Waterproof Case rated IP68 Power Factor Correction Short Circuit Protection Model Max Output Power (W) ① Output Voltage ③ Range (V) Output Current ③ (A) Input Voltage (VAC/Hz) Input Voltage (VDC) AMER90-50180AZ 90 36-50 0-1.8 90-305/47-440 120-430 24-36 0-2.5 90-305/47-440 120-430 12-24 0-3.75 90-305/47-440 120-430 AMER90-36250AZ AMER90-24375AZ 90 90 Mode of Operation Efficiency (%) Constant Current 91 89 90 88 89 88 Constant Voltage ② Constant Current Constant Voltage ② Constant Current Constant Voltage ② Add Suffix “-F” No dimming option Exceeding the maximum output power will permanently damage the converter ② The dimming feature is not supported when units are used in Constant Voltage mode only, Aimtec suggests to order “-F” No dimming option in this case. ③ In constant current mode output current is maximum shown, in constant voltage mode output voltage is the maximum shown. NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. ① Input Specifications Parameters Inrush current <2ms Leakage current AC current Power Factor External fuse Start up time Surge voltage Conditions Typical 115VAC 230VAC 115VAC 230VAC 115VAC 230VAC 115VAC 230VAC 40 50 0.5 0.75 1.4 0.46 Maximum Units A mA A 0.98 0.94 250V/2.5A 700 2sec 440 ms V Maximum Units Output Specifications Parameters Conditions Typical Current accuracy ±3 Line regulation LL-HL ±1 Load regulation 0-100% load ±0.3 20MHz Bandwidth 75 Ripple & Noise ④ Hold-up time 100 Current adjustment range 100-0 Minimum Load Voltage See the models table ④ Tested with 0.1µF (C/C) or (M/C) and 47µF (E/C) parallel capacitors at the end. www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 1 of 10 % % % mV p-p ms % Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMER90-AZ up to 3.75A | AC-DC / DC-DC | LED Driver / Converter Isolation Specifications Parameters Conditions Tested I/O voltage Isolation Resistance Isolation Capacitance Typical 3sec 500VDC Rated Units 3000 VAC MΩ pF >1000 1000 General Specifications Parameters Switching frequency Over current protection Over voltage protection Short circuit protection Short circuit restart Over temperature protection Operating temperature Maximum case temperature Storage temperature Temperature coefficient Cooling Humidity Case material Potting Wires Weight Dimensions (L X H X W) MTBF Conditions Typical See derating table 100 95-110% of Iout 110% of Vout Continuous Auto recovery >105°C -40 to +85 Maximum Units KHz o 100 -40 to +95 ±0.02 Free air convection 95 Aluminum Epoxy (IP67 rated) UL1015 18AWG *20CM 750 7.13 x 2.32 x 1.85 inches 181.00 x 59.00 x 47.00 mm >400,000 hrs (MIL-HDBK-217F at +25°C) C C o C o %/ C o % RH g Safety Specifications Parameters Agency approvals Standards www.aimtec.com F 052.1e R3.S cULus, CE UL8750, UL60950-1, EN55022, class B, EN60529(IP68), EN61347-1, EN61347-2-13 Information Technology Equipment EN55022 Class B Harmonic Current Emissions IEC/EN 61000-3-2, Class C Voltage fluctuations and flicker IEC/EN 61000-3-3, (EN60555-3) Electrostatic Discharge Immunity IEC 61000-4-2 RF, Electromagnetic Field Immunity IEC 61000-4-3 Electrical Fast Transient / Burst Immunity IEC 61000-4-4 Surge Immunity IEC 61000-4-5 RF, Conducted Disturbance Immunity IEC 61000-4-6 Power frequency Magnetic Field Immunity IEC 61000-4-8 Voltage dips, Short Interruptions Immunity IEC 61000-4-11 Tel: +1 514 620 2722 2 of 10 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMER90-AZ up to 3.75A | AC-DC / DC-DC | LED Driver / Converter Dimensions Analog (resistive) Dimming Application Circuit Model Number AMER90-50180AZ AMER90-36250AZ AMER90-24375AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 3 of 10 Maximum Pot Value (kΩ) 15.00 24.00 16.95 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMER90-AZ up to 3.75A | AC-DC / DC-DC | LED Driver / Converter R28 1K5, 0805 0-10V Dimming Application Circuit Temperature Graph www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 4 of 10 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMER90-AZ up to 3.75A | AC-DC / DC-DC | LED Driver / Converter Efficiency vs. Input Voltage and Output Current (CC Load) AMEPR90-50180AZ AMER90-36250AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 5 of 10 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMER90-AZ up to 3.75A | AC-DC / DC-DC | LED Driver / Converter Efficiency vs. Input Voltage and Output Current (CC Load) (continued) AMER90-24375AZ PFC Value vs. Output Load Current (CC Load) AMEPR90-50180AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 6 of 10 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMER90-AZ up to 3.75A | AC-DC / DC-DC | LED Driver / Converter PFC Value vs. Output Load Current (CC Load) (continued) AMER90-36250AZ AMER90-24375AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 7 of 10 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMER90-AZ up to 3.75A | AC-DC / DC-DC | LED Driver / Converter Constant Current Mode vs. Constant Voltage Mode AMEPR90-50180AZ AMER90-36250AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 8 of 10 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMER90-AZ up to 3.75A | AC-DC / DC-DC | LED Driver / Converter Constant Current Mode vs. Constant Voltage Mode (continued) AMER90-24375AZ Output Current vs. Radj AMEPR90-50180AZ www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 9 of 10 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMER90-AZ up to 3.75A | AC-DC / DC-DC | LED Driver / Converter Output Current vs. Radj (continued) AMER90-36250AZ AMER90-24375AZ NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity<75%, nominal input voltage and at rated output load unless otherwise specified. 5. Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 6. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. 7. Warranty is in accordance with Aimtec’s standard Terms of Sale available at www.aimtec.com. www.aimtec.com F 052.1e R3.S Tel: +1 514 620 2722 10 of 10 Toll free: + 1 888 9 AIMTEC (924 6832) North America only