RF Amplifier 1 to 30 MHz Model BXMP1050 FEATURES • Ultra High Linearity • High Output Power @ 1 dB Comp. • High Reverse Isolation • Environmental Screening Available The Model BXMP1050 is standard high linearity amplifier covering 1 MHz to 30 MHz. This HF amplifier, utilizes a two stage, high linearity push-pull design and a laser sealed housing for the ultimate in environmental protection. This standard design may also be ordered in a screened MIL-STD-883 version as a model SXMP1050. All specification ratings are based on measurements in a 50 ohm system with a DC supply voltage tolerance of +/- 2%. Parameter Typical Min. / Max. Frequency Range Gain Gain Flatness (+/-) Pout @ 1 dB Compression Input VSWR Output VSWR Reverse Isolation 3rd Order Output Intercept Point** 2nd Order Output Intercept Point** Noise Figure Supply Voltage Supply Current 1 to 30 MHz 16 dB 0.5 dB 31.5 dBm 1.5:1 1.5:1 40 dB +58 dBm +113 dBm 6.0 dB +24 volts 450 mA 1 to 30 MHz 15 dB /17 dB 0.5 dB Max. +31 dBm Min. 1.6:1 Max. 1.6:1 Max. +55 dBm Min. +110 dBm Min. 7.0 dB +24 volts 475 mA Max. **Intercept Point Values are Tested only at Midband. *Pin = +20 dBm max with output terminated at 50 Ώ Revision: 9/24/2012 Housing Size RF Connectors Operating Case Temp. (Min./Max. Values) Typical values are measured at 25°C but not guaranteed. 2.980" L x 3.905" W x 0.757" H SMA Female 0°C to +50°C Maximum (No Damage) Ratings Storage Temperature Operating Temperature (Case) DC Voltage @ 25°C (Regulated) Input Drive @ 25°C (CW)* -65°C to +125°C -40°C to +85°C +25 VDC +20 dBm Spectrum Microwave, Inc. • PH: 888.553.7531 • Fax: 888.553.7532 • Email: [email protected] • www.SpectrumMicrowave.com RF Amplifier 1 to 30 MHz Model BXMP1050 Outline Drawing Spectrum Microwave, Inc. • PH: 888.553.7531 • Fax: 888.553.7532 • Email: [email protected] • www.SpectrumMicrowave.com