ETC 74LVQ02SJX

Revised June 2001
74LVQ02
Low Voltage Quad 2-Input NOR Gate
General Description
Features
The LVQ02 contains four 2-input NOR gates.
■ Ideal for low power/low noise 3.3V applications
■ Guaranteed simultaneous switching noise level and
dynamic threshold performance
■ Guaranteed pin-to-pin skew AC performance
■ Guaranteed incident wave switching into 75Ω
Ordering Code:
Order Number
Package Number
Package Description
74LVQ02SC
M14A
14-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-012, 0.150" Narrow
74LVQ02SJ
M14D
14-Lead Small Outline Package (SOP), EIAJ TYPE II, 5.3mm Wide
Devices also available in Tape and Reel. Specify by appending the suffix letter “X” to the ordering code.
Logic Symbol
Connection Diagram
IEEE/IEC
Pin Descriptions
Pin Names
© 2001 Fairchild Semiconductor Corporation
Description
An , Bn
Inputs
On
Outputs
DS011342
www.fairchildsemi.com
74LVQ02 Low Voltage Quad 2-Input NOR Gate
February 1992
74LVQ02
Absolute Maximum Ratings(Note 1)
Recommended Operating
Conditions (Note 2)
−0.5V to +7.0V
Supply Voltage (VCC)
DC Input Diode Current (IIK)
Supply Voltage (VCC)
VI = −0.5V
−20 mA
VI = VCC + 0.5V
+20 mA
DC Input Voltage (VI)
LVQ
−0.5V to VCC + 0.5V
DC Output Diode Current (IOK)
0V to VCC
Output Voltage (VO)
0V to VCC
Operating Temperature (TA)
VO = −0.5V
−20 mA
VO = VCC + 0.5V
+20 mA
DC Output Voltage (VO)
−40°C to +85°C
74LVQ
Minimum Input Edge Rate (∆V/∆t)
−0.5V to VCC + 0.5V
VIN from 0.8V to 2.0V
DC Output Source
VCC @ 3.0V
±50 mA
or Sink Current (IO)
±200 mA
(ICC or IGND )
125 mV/ns
Note 1: The “Absolute Maximum Ratings” are those values beyond which
the safety of the device cannot be guaranteed. The device should not be
operated at these limits. The parametric values defined in the Electrical
Characteristics tables are not guaranteed at the absolute maximum ratings.
The “Recommended Operating Conditions” table will define the conditions
for actual device operation.
DC VCC or Ground Current
Storage Temperature (TSTG)
2.0V to 3.6V
Input Voltage (VI)
−65°C to +150°C
DC Latch-Up Source or
Note 2: Unused inputs must be held HIGH or LOW. They may not float.
±100 mA
Sink Current
DC Electrical Characteristics
Symbol
VIH
Parameter
Minimum High Level
Input Voltage
VIL
Maximum Low Level
Input Voltage
VOH
Minimum High Level
Output Voltage
VOL
Maximum Low Level
Output Voltage
IIN
Maximum Input
TA = +25°C
VCC
TA = −40°C to +85°C
Units
(V)
Typ
3.0
1.5
2.0
2.0
V
3.0
1.5
0.8
0.8
V
3.0
2.99
2.9
2.9
V
3.0
2.58
2.48
V
0.1
0.1
V
3.0
0.36
0.44
V
3.6
±0.1
3.0
0.002
Conditions
Guaranteed Limits
VOUT = 0.1V
or VCC − 0.1V
VOUT = 0.1V
or VCC − 0.1V
IOUT = −50 µA
VIN = VIL or VIH (Note 3)
IOH = −12 mA
IOUT = 50 µA
VIN = VIL or VIH (Note 3)
IOL = 12 mA
±1.0
µA
IOLD
Minimum Dynamic (Note 4)
3.6
36
mA
VOLD = 0.8V Max (Note 5)
IOHD
Output Current
3.6
−25
mA
VOHD = 2.0V Min (Note 5)
ICC
Maximum Quiescent
20.0
µA
Leakage Current
Supply Current
VOLP
Quiet Output
Maximum Dynamic VOL
VOLV
Quiet Output
Minimum Dynamic VOL
VIHD
Maximum High Level
Dynamic Input Voltage
VILD
Maximum Low Level
Dynamic Input Voltage
3.6
2.0
VI = VCC, GND
VIN = VCC
or GND
3.3
0.6
1.0
V
(Note 6)(Note 7)
3.3
−0.7
−1.0
V
(Note 6)(Note 7)
3.3
1.7
2.0
V
(Note 6)(Note 8)
3.3
1.7
0.8
V
(Note 6)(Note 8)
Note 3: All outputs loaded; thresholds on input associated with output under test.
Note 4: Maximum test duration 2.0 ms, one output loaded at a time.
Note 5: Incident wave switching on transmission lines with impedances as low as 75Ω for commercial temperature range is guaranteed for 74LVQ.
Note 6: Worst case package.
Note 7: Max number of outputs defined as (n). Data inputs are driven 0V to 3.3V; one output at GND.
Note 8: Max number of Data Inputs (n) switching. (n − 1) inputs switching 0V to 3.3V. Input-under-test switching: 3.3V to threshold (VILD), 0V to threshold
(VIHD), f = 1 MHz.
www.fairchildsemi.com
2
TA = +25°C
Symbol
tPLH
tPHL
Propagation Delay
tOSHL,
Output to Output Skew (Note 9)
Data to Output
CL = 50 pF
(V)
Min
Typ
Max
Min
Max
2.7
1.5
6.0
10.6
1.0
12.0
3.3 ± 0.3
1.5
5.0
7.5
1.0
8.0
2.7
1.5
6.0
10.6
1.0
12.0
3.3 ± 0.3
1.5
5.0
7.5
1.0
8.0
2.7
1.0
1.5
1.5
3.3 ± 0.3
1.0
1.5
1.5
Propagation Delay
tOSLH
TA = −40°C to +85°C
CL = 50 pF
VCC
Parameter
Units
ns
ns
ns
Note 9: Skew is defined as the absolute value of the difference between the actual propagation delay for any two separate outputs of the same device. The
specification applies to any outputs switching in the same direction, either HIGH-to-LOW (tOSHL) or LOW-to-HIGH (tOSLH). Parameter guaranteed by design.
Capacitance
Typ
Units
CIN
Symbol
Input Capacitance
Parameter
4.5
pF
VCC = Open
Conditions
CPD (Note 10)
Power Dissipation Capacitance
20
pF
VCC = 3.3V
Note 10: CPD is measured at 10 MHz.
3
www.fairchildsemi.com
74LVQ02
AC Electrical Characteristics
74LVQ02
Physical Dimensions inches (millimeters) unless otherwise noted
14-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-012, 0.150" Narrow
Package Number M14A
www.fairchildsemi.com
4
74LVQ02 Low Voltage Quad 2-Input NOR Gate
Physical Dimensions inches (millimeters) unless otherwise noted (Continued)
14-Lead Small Outline Package (SOP), EIAJ TYPE II, 5.3mm Wide
Package Number M14D
Fairchild does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and
Fairchild reserves the right at any time without notice to change said circuitry and specifications.
LIFE SUPPORT POLICY
FAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT
DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT OF FAIRCHILD
SEMICONDUCTOR CORPORATION. As used herein:
2. A critical component in any component of a life support
device or system whose failure to perform can be reasonably expected to cause the failure of the life support
device or system, or to affect its safety or effectiveness.
1. Life support devices or systems are devices or systems
which, (a) are intended for surgical implant into the
body, or (b) support or sustain life, and (c) whose failure
to perform when properly used in accordance with
instructions for use provided in the labeling, can be reasonably expected to result in a significant injury to the
user.
www.fairchildsemi.com
5
www.fairchildsemi.com