Compact Single and Three Phase Torque Vector Systems for Small Three Phase Motors JAGUAR VXS Sensorless Vector Variable Frequency Inverters 0.4kW to 4.0kW ■ High performance Torque Vector Control ■ Over 200% torque at 1 Hz ■ Footprint filters for EMC compliance ■ User friendly auto tuning ■ Ultra compact IP40 enclosure ■ Fast torque response ■ Low motor noise profile ■ User programmable I/O ■ Integral detachable keypad ■ Single and three phase versions ■ RS485 communications port (optional) ■ Renowned IMO 5 year warranty 5 Electrical specifications Single Phase Input Three Phase Input VXS20-1 VXS40-1 VXS75-1 VXS150-1 VXS220-1 VXS40-3 VXS75-3 VXS150-3 Motor rating (kW) 0.2 0.37 0.55 0.75 1.5 2.2 0.37 0.55 0.75 1.5 2.2 4.0 Maximum rated O/P current (A) 1.5 3.0 5.0 8.0 11.0 1.6 2.5 3.7 5.5 9.0 100% Rated I/P current ARMS 2.95 4.1 7.2 14.0 20.0 1.3 2.2 4.3 6.0 9.8 Jaguar VXS order codes 200 - 240 AC, ±10%, 1 phase Input voltage VXS220-3 VXS400-3 380 - 480 AC, +10 to -15%, 3 phase Input frequency 50 - 60 Hz, ±5% Output voltage AC, 0 - VINPUT PWM Output frequency 0.2 - 400 Hz PRICE INFORMATION AND ORDERING General specifications Heat loss at minimum carrier frequency (W) 23 45 56 81 129 42 51 67 97 120 Weight (Kg) 1.1 1.6 1.7 2.7 2.8 1.8 1.8 2.7 2.7 3.2 Enclosure rating Cooling method Ambient temperature Relative humidity Vibration Altitude IP40 Natural Convection Fan Assisted Natural Convection -10 to +50˚C (remove covers >+40˚C) 20 to 95% non condensing 5.9 m/s2 (0.6G) max 1000 metres max Fan Assisted Jaguar VXS Connection diagram WARNING! This equipment must be earthed C F 240V 1Ø or 415V 3Ø 50/60 Hz CAUTION: Do not short circuit. Terminal P24 to terminal 11, CM or CME L1 U PANEL CONTROL F L2 (L) F L3 (N) PRG MODE Hz A r/min m/min PRICE INFORMATION AND ORDERING RUN V V PRG RESET RUN FUNC DATA STOP M W NOTE: Figures in brackets are for single phase models Frequency reference current input (4~20 mA DC) (+) (–) C1 GND(PE) GND(P E) DC REACTOR (OPTIONAL) P1 LINK 13 Manual frequency setting potentiometer (10KΩ/1W) 12 (+) EXTERNAL BRAKE RESISTOR (OPTIONAL) 11 DB P24 +24V Forward operation and stop command FWD Reverse operation and stop command REV Coast - to - stop command 30A 30B BX 30C Alarm reset RST X1 Multistep frequency select FMP X2 X3 Function extension input From P24* terminal From THR terminal Alarm output (any fault) (Relay shown in power ON or OFF and healthy state) PULSE To CM terminal FMA X4 To terminal 11 CM External alarm input THR Digital frequency meter YIE CMC Analog frequency meter (10 V/1 mA DC) Programmable output Common for YIE * NOTE: Under no circumstances should the above guide be considered sufficient for the attainment of relevant EMC emission limits. Please consult the product manual for full information regarding compliance. Power Terminals Symbol Terminal Name Description L1, L2, L3 Main input power terminals For connecting 3 phase power supply (VXS - 3 only) L, N Main input power terminals For connecting single phase power supply (VXS - 1 only) U, V, W Power output terminals For 3 phase AC induction motor P1, (+) DC reactor terminals (+), DB External brake resistor terminals Connection for brake resistor to increase braking torque GND (PE) Earth terminal Safety electrical earth Optional DC reactor terminals for improving power factor (fitted with shorting link) Jaguar VXS Control circuit terminals Purpose Analog Frequency Setting Terminal Terminal Name Description 11 Speed reference 0V common For use with terminals 12, 13, C1 and FMA 12 Reference input 0 - 10V DC input, impedance = 22 KΩ 13 Potentiometer supply +10V DC power supply for 1 KΩ speed control potentiometer. Output 10mA max. C1 Current loop input 4 - 20mA input, impedance = 250Ω FWD Forward and stop command FWD - P24 Closed – Motor runs forward Open – Motor stops REV Reverse and stop command REV - P24 Closed – Motor runs in reverse Open – Motor stops Coast - to - Stop command BX - P24 Closed – Output inhibited instantaneously Open – Normal External trip • THR - P24 Closed – Normal Open – Trips output instantaneously or • THR - P24 Closed – Normal Open – Data protected BX THR or Enable/disable data edit mode Control Inputs RST X1, X2, X3 Trip/Alarm reset If RST - P24 is closed for ≥100mS following a trip condition, the inverter will reset Preset speeds Combinations of X1, X2, X3 - P24 will call for preset frequencies to be output X4 Function extension Depending upon the setting of function No. 43 terminal acts as – Acc 2 / Dec 2 pattern select – Extension to 15 preset speeds – 2nd motor V/F profile – FWD/REV latch for 3-wire I/P P24 +24V DC supply Internal 24V DC supply for control inputs CM Common terminal Common terminal for FMP and digital inputs FMA Analogue output Output frequency, current, torque or load factor can be selected, 0 - 10V DC, 1mA maximum Up to 2 metres of cable is recommended for connection to this terminal FMP Digital output YIE Programmable output Selectable for:1) Inverter running 2) Frequency level detected 3) Frequency hysteresis band reached 4) Undervoltage trip 5) Torque limiting 6) Auto Restart Maximum 27V DC, 50 mA Common terminal Used for YIE output only Fault relay Normally 30B - 30C closed with power OFF or ON, with drive output healthy 30A - 30C closes on fault. Rated 250V, 0.3A Meter Outputs Control Outputs If both FWD and REV are opened or closed, then the inverter output stops CMC 30A 30B 30C Output proportional to frequency of motor 6 kHz maximum, fully scalable Jaguar VXS Dimensions (mm) VXS40-1 and VXS75-1 (Single Phase) VXS40-3 and VXS75-3 (Three Phase) Remote mountable keypad with optional cable 2 holes, 5mm 65 6 PANEL CONTROL 6 5 * 30 PRG MODE Hz A r/min m/min RUN RUN FUNC DATA STOP * 30 Removable side-cover V PRG RESET * PANEL CONTROL 138 150 PRG MODE Hz A r/min m/min PRG RESET RUN FUNC DATA STOP 5 45 * 128 75 140 109 *Centrelines of 3 cable entry holes, 22mm dia. VXS150-1 and VXS220-1 (Single Phase) VXS150-3 and VXS220-3 (Three Phase) 2 holes, 5mm 6 PANEL CONTROL 6 5 * PRG MODE Hz A r/min m/min RUN RUN FUNC DATA STOP * 30 138 150 6 5 * 30 Removable side-cover V PRG RESET 188 200 5 * 71 100 134 *Centrelines of 3 cable entry holes, 22mm dia. VXS400-3 (Three Phase) 2 holes, 5mm 6 PANEL CONTROL 6 5 * 188 200 30 67.5 RUN V 85 6 5 12.3 7.9 PRG MODE Hz A r/min m/min RUN PRG RESET RUN FUNC DATA STOP * 30 Removable side-cover V * 138 150 5 6 5 * 86 115 149 *Centrelines of 3 cable entry holes, 22mm dia. PRICE INFORMATION AND ORDERING