PA1131 850-900 MHz. Ultra Linear Amplifier Features (Typical Values) High IP3 .................................................... 49.0 dBm. High Pout @ 1dB. comp. ........................ +33.0 dBm. Low Noise Figure ...........................................2.5 dB. Low Cost Electrical Specifications Parame te r Typical Value Frequency (Referenced to 50 ohms) Typical Performance Curves M in. Value M ax. Value Units 850 9 00 MHz. G a in (d B .) v s . F r e q u e n c y 2 7 .6 2 7 .4 Gain 2 7 .5 26.5 dB. 2 7 .2 850 Gain Flatness Reverse Isolation ±0.3 ±0.5 40 3 3 .0 31.5 Noise Figure 2.5 IP3 49.0 VSWR 1.3:1 1.5:1 +15/700 +15/800 48.0 880 890 900 N F (d B ) v s . F re q u e n c y 3 2 .7 5 2 .5 2 .2 5 2 dBm. 3 .2 870 dB. dB. Pout @ 1dB. comp. 860 dB. 850 860 870 880 890 900 dBm. P o u t (d B m ) v s . F re q u e n c y Supply Req'd 34 v./mA. 33 32 IP3 measured with 2 tones @ +15 dBm. per tone , 1 Mhz apart Min and max values from 0 to 85 degrees C Unit requires an external 12 ohm, 10 watt resistor from pin #4 to gnd. 850 860 870 880 890 900 V S W R v s. F req u en cy In O ut 1 .4 1 .3 1 .2 1 .1 Outline Drawings 850 860 870 880 890 900 IP 3 ( d B m ) v s . F r e q u e n c y 50 49 48 850 860 870 880 890 900 F r e q u e n c y in M H z . Maximum Ratings Storage Temperature ......... -40°C to +85°C DC Voltage .................................. +17 volts RF Input Power ........................... +15 dBm. Case Temperature ............................ +95°C Specifications subject to change without notice Rev: 041701 100 Emlen Way Telford, Pa. 18969 Tel. (215) 723-6011 Fax. (215) 723-6015