LPC-35 35W Single Output Switching Power Supply series Features : Constant current design Universal AC input / Full range Withstand 300VAC surge input for 5 seconds Protections: Short circuit / Over voltage Cooling by free air convection Fully encapsulated with IP67 level (Note.8) Fully isolated plastic case Class power unit, no FG Pass LPS Suitable for LED lighting and moving sign applications (Note.7) 100% full load burn-in test Low cost, high reliability 2 years warranty LPS IP67 SPECIFICATION MODEL LPC-35-700 LPC-35-1050 LPC-35-1400 700mA 1050mA 1400mA DC VOLTAGE RANGE 9 ~ 48V 9 ~ 30V 9 ~ 24V RATED POWER 33.6W 31.5W 33.6W 200mVp-p 200mVp-p VOLTAGE TOLERANCE Note.3 5.0% CURRENT ACCURACY 5.0% LINE REGULATION 1.0% 2.0% LOAD REGULATION SETUP, RISE TIME Note.6 500ms, 120ms / 230VAC 50ms/230VAC HOLD UP TIME (Typ.) VOLTAGE RANGE INPUT Note.4 90 ~ 264VAC EFFICIENCY (Typ.) 85% AC CURRENT (Typ.) INRUSH CURRENT(max.) 1.1A/115VAC 0.7A/230VAC COLD START 30A/115VAC LEAKAGE CURRENT 0.25mA / 240VAC WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT 50.4 ~ 60V 31.5 ~ 40.5V 27.6 ~ 32.4V Protection type : Shut off o/p voltage, clamping by zener diode -30 ~ +75 (Refer to "Derating Curve") 20 ~ 90% RH non-condensing -40 ~ +80 , 10 ~ 95% RH VIBRATION SAFETY STANDARDS UL1310 Class 2, CAN/CSA C22.2 No. 223-M91(except for LPC-35-700), IP67 approved ; design refer to TUV EN60950-1, EN61347-2-13 WITHSTAND VOLTAGE I/P-O/P:3KVAC ISOLATION RESISTANCE I/P-O/P:>100M Ohms / 500VDC / 25 / 70% RH Compliance to EN55022 (CISPR22) Class B, EN61000-3-2 Class A, EN61000-3-3 EMC EMISSION EMC IMMUNITY DIMENSION PACKING NOTE 60A/230VAC 0.03%/ (0 ~ 50 ) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes MTBF OTHERS 127 ~ 370VDC 47 ~ 63Hz WORKING TEMP. EMC 500ms, 120ms / 115VAC at full load 16ms/115VAC at full load FREQUENCY RANGE PROTECTION OVER VOLTAGE SAFETY & ( except for 700mA ) RATED CURRENT RIPPLE & NOISE (max.) Note.2 200mVp-p OUTPUT ( for 700mA only) Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, light industry level, criteria A 743.5Khrs min. MIL-HDBK-217F (25 ) 148*40*30mm (L*W*H) 0.34Kg; 40pcs/14.6Kg/0.63CUFT 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. Derating may be needed under low input voltage. Please check the static characteristics for more details. 5. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again. 6. Length of set up time is measured at first cold start. Turning ON/OFF the power supply may lead to increase of the set up time. 7. In the European market this power supply can be used for LED lighting applications with input power up to 25W. 8. Suitable for indoor use or outdoor use without direct sunlight exposure. Please avoid immerse in the water over 30 minute. File Name:LPC-35-SPEC 2011-06-24 LPC-35 35W Single Output Switching Power Supply Mechanical Specification Case No. 975A 600 30 148 series Unit:mm 600 30 UL1015 18AWG 40 3.6 T case 3.6 26.5 UL1007 16AWG +V(Red) -V(Black) 18 3.5 AC/N(Blue) AC/L(Brown) 3.5 3.5 3.5 30 T case: Max. Case Temperature. Recommend Mounting Direction Block Diagram fosc : 60KHz EMI FILTER & RECTIFIERS I/P RECTIFIERS & FILTER POWER SWITCHING +V -V O.C.P. O.L.P. DETECTION CIRCUIT PWM CONTROL Derating Curve Static Characteristics 100 100 90 80 80 70 LOAD (%) LOAD (%) 60 40 20 -30 0 15 30 40 50 60 AMBIENT TEMPERATURE ( ) 70 75 80 (HORIZONTAL) 60 50 40 90 100 125 135 145 155 165 175 180 200 230 264 INPUT VOLTAGE (V) 60Hz File Name:LPC-35-SPEC 2011-06-24