MDA100G THRU MDA110G SINGLE-PHASE GLASS PASSIVATED SILICON BRIDGE RECTIFIER VOLTAGE RANGE 50 to 1000 Volts CURRENT 1.0 Ampere d e it nu FEATURES * * * * * n o isc Low cost Low leakage Low forward voltage Mounting position: Any Weight: 1.26 grams D MECHANICAL DATA RS-1 * UL listed the recognized component directory, file #E94233 * Epoxy: Device has UL flammability classification 94V-O .360 (9.1) .414 (10.5) .374 (9.5) .320 (8.1) AC DISCONTINUED- .390 "This series is replaced by the RS10X series that meets to the same fit and function parameters. The RS10X series is preferred for PCB assembly.＂ .035 (0.9) DIA. (9.9) MIN. .028 (0.7) TYP. .160 (4.1) SPACING .140 (3.6) .650 (16.5) .610 (15.5) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 o C ambient temperature unless otherwise specified. .161 (4.1) .150 (3.8) Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. .050 (1.27) Dimensions in inches and (millimeters) MAXIMUM RATINGS (@ TA=25 OC unless otherwise noted) RATINGS SYMBOL MDA100G MDA101G MDA102G MDA104G MDA106G MDA108G MDA110G UNITS Maximum Recurrent Peak Reverse Voltage VRRM 50 100 200 400 600 800 1000 Volts Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 Volts VDC 50 100 200 400 600 800 1000 Volts Maximum DC Blocking Voltage Maximum Average Forward Rectified Current at T A = 50 o C Peak Forward Surge Current 8.3 ms single half sine-wave superimposed on rated load (JEDEC method) Typical Thermal Resistance (Note 1) Operating and Storage Temperature Range IO 1.0 Amps I FSM 30 Amps R q JC 15 0 R q JA 50 T J, T STG -55 to + 150 C/ W 0 C ELECTRICAL CHARACTERISTICS (@TA=25 OC unless otherwise noted) CHARACTERISTICS Maximum Instantaneous Forward Voltage at 1.57A DC Maximum DC Reverse Current at Rated DC Blocking Voltage @T A = 25 o C @T A = 100 o C SYMBOL MDA100G MDA101G MDA102G MDA104G MDA106G MDA108G MDA110G UNITS VF 1.3 Volts IR NOTES : 1. Thermal Resistance : Heat-sink case mounted or if PCB mounted. 2. "Fully ROHS compliant", "100% Sn plating (Pb-free)". 5.0 1000 uAmps 2007-5 AVERAGE FORWARD CURRENT, (A) 1.0 0.8 0.6 0.4 Single Phase Half Wave 60 Hz Inductive or Resistive Load 0.2 0 0 50 100 150 INSTANTANEOUS FORWARD CURRENT, (A) RATING AND CHARACTERISTICS CURVES ( MDA100G THRU MDA110G ) 4 1.0 0.4 0.1 0.04 0.01 T A = 25 OC Pulse Width = 300mS 1% Duty Cycle 0 O FIG.1 TYPICAL FORWARD CURRENT DERATING CURVE 10000 TA = 100 OC 1000 100 10 TA = 25 OC 1 0 20 40 60 80 100 0.5 1.0 1.5 2.0 2.5 3.0 3.5 INSTANTANEOUS FORWARD VOLTAGE, (V) PEAK FORWARD SURGE CURRENT, (A) INSTANTANEOUS REVERSE CURRENT, (uA) AMBIENT TEMPERATURE, ( C) 120 140 PERCENT RATED PEAK REVERSE VOLTAGE, (%) FIG.3 TYPICAL REVERSE CHARACTERISTICS 30 FIG.2 TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 8.3mS Single Half Sine-Wave JEDEC Method 25 20 15 10 5 0 1 2 5 10 20 50 100 NUMBER OF CYCLES AT 60Hz FIG.4 MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT DISCLAIMER NOTICE Rectron Inc reserves the right to make changes without notice to any product specification herein, to make corrections, modifications, enhancements or other changes. Rectron Inc or anyone on its behalf assumes no responsibility or liability for any errors or inaccuracies. Data sheet specifications and its information contained are intended to provide a product description only. "Typical" parameters which may be included on RECTRON data sheets and/ or specifications can and do vary in different applications and actual performance may vary over time. Rectron Inc does not assume any liability arising out of the application or use of any product or circuit. Rectron products are not designed, intended or authorized for use in medical, life-saving implant or other applications intended for life-sustaining or other related applications where a failure or malfunction of component or circuitry may directly or indirectly cause injury or threaten a life without expressed written approval of Rectron Inc. Customers using or selling Rectron components for use in such applications do so at their own risk and shall agree to fully indemnify Rectron Inc and its subsidiaries harmless against all claims, damages and expenditures.