Order this document by MHW916/D SEMICONDUCTOR TECHNICAL DATA The RF Line Designed specifically for the European Digital Extended Group Special Mobile (GSM) Base Station applications in the 925–960 MHz frequency range. MHW916 operates from a 26 Volt supply and requires 15.5 dBm of RF input power. • Specified 26 Volt Characteristics RF Input Power: 15.5 dBm Max RF Output Power: 16 Watts at 1.0 dB Compression Point Minimum Gain: 26.5 dB Harmonics: –35 dBc Max at 2Fo 16 WATT 925–960 MHz RF POWER AMPLIFIER • 50 Ω Input/Output System • Meet GSM Linearity Specification for Base Station up to 12.5 Watts CASE 301AB– 02, STYLE 1 MAXIMUM RATINGS Symbol Value Unit DC Supply Voltage Parameter VS 28 Vdc DC Bias Voltage VB 16 Vdc Pin 19 dBm Pout 25 W RF Input Power RF Output Power Operating Case Temperature Range TC – 5.0 to +85 °C Storage Temperature Range Tstg – 30 to +100 °C Istdby 400 mA Standby Current (Pin Removed, Istdby = IS1 + IS2) ELECTRICAL CHARACTERISTICS (TC = 25°C, VS1 = VS2 = 26 Vdc, Vbias = 15 Vdc, 50 ohm system) Characteristic Symbol Min Typ Max Unit BW 925 — 960 MHz Idq1 + Idq2 — 400 — mA Gp 26.5 30 32.5 dB P1dB 16 — — W Efficiency (1.0 dB Compression Power) η1 37 44 — % Efficiency (Pout = 16 W) (1) η2 33 39 — % Frequency Range Quiescent Current (Pin = 0 mW) Power Gain (Pout = 16 W) (1) Output Power at 1.0 dB Compression Input VSWR (Pout = 16 W) (1) VSWRin — — 2:1 — Harmonic 2 fo (Pout = 16 W) (1) H2 — –40 –35 dBc Harmonic 3 fo (Pout = 16 W) (1) H3 — –60 –45 dBc Ripple (Pout = 16 W) (1) Rp — 1.0 — dB Load Mismatch Stress (Pout = 16 W) Load VSWR = 5:1, All Phase Angles Ψ No Degradation in Output Power Stability (Pout = 10 mW to 16 W) Load VSWR = 3:1, All Phase Angles (Except Harmonics) — All Spurious Outputs More Than 60 dB Below Desired Signal Stability (Pout = –5.0 dBm to 42 dBm, f = 925 to 960 MHz) Load VSWR = 2:1, All Phase Angles — All Spurious Outputs Lower Than –46 dBm or –85 dBc (Whichever the Higher) (1) Adjust Pin for Specified Pout. REV 3 RF DEVICE DATA MOTOROLA Motorola, Inc. 1997 MHW916 1 MHW916 BLOCK DIAGRAM OUTPUT POWER METER INPUT POWER METER REFLECTED POWER METER 2 1 C4 C1 3 TEST FIXTURE C5 5 C6 C7 C8 Z1 4 C2 C9 C3 RF IN 20 dB DUAL DIRECTIONAL COUPLER Vbias 15 V RF SIGNAL GENERATOR Z2 RF OUT 20 dB DUAL DIRECTIONAL COUPLER 10 dB MINIMUM ATTENUATION SPECTRUM ANALYZER VS2 26 V VS3 26 V POWER TERMINATION C1, C2, C3 C4, C5, C6 C7, C8, C9 Z1, Z2 0.018 µF 0.1 µF 1.0 µF 50 Ω Microstrip Figure 1. MHW916 Test Circuit Diagram MHW916 2 MOTOROLA RF DEVICE DATA TYPICAL CHARACTERISTICS VS = 26 Vdc Vbias = 15 Vdc Pout = 16 W TC = 25°C 10 5:1 INPUT VSWR 4:1 GP , POWER GAIN (dBm) 20 POWER GAIN VSWR in,INPUT VSWR 30 GP, POWER GAIN (dB) 60 32 3:1 0 30 GP @ Pout = 12.5 W 28 GP @ Pout = 20 W 26 55 VS = 26 Vdc 50 Vbias = 15 Vdc TC = 25°C 45 η @ Pout = 20 W η @ Pout = 16 W 24 40 η @ Pout = 12.5 W 22 η, EFFICIENCY (%) 40 35 2:1 –10 450 550 650 750 950 850 f, FREQUENCY (MHz) 1050 20 925 1:1 1150 50 40 38 EFFICIENCY f = 925 MHz & 960 MHz 36 VS = 26 Vdc Vbias = 15 Vdc 20 TC = 25°C 34 32 30 30 5 7 9 11 13 Pin, INPUT POWER (dBm) 15 17 GP , POWER GAIN (dBm) 960 MHz TC = –5°C 31 η, EFFICIENCY (%) P out , OUTPUT POWER (dBm) OUTPUT POWER 40 30 TC = 25°C 29 28 TC = 85°C 27 VS = 26 Vdc Vbias = 15 Vdc Pout = 16W 26 25 925 10 30 28 f = 925 MHz 24 940 MHz 22 20 960 MHz VS = 26 Vdc Vbias = 15 Vdc 18 16 14 –5 5 15 25 35 45 55 65 75 85 930 935 940 945 950 f, FREQUENCY (MHz) 955 960 Figure 5. Power Gain versus Frequency P1dB, OUTPUT POWER AT 1dB COMPRESSION (W) P1dB, OUTPUT POWER AT 1dB COMPRESSION (W) Figure 4. Output Power and Efficiency versus Input Power 26 30 960 955 32 60 f = 925 MHz 950 Figure 3. Power Gain and Efficiency versus Frequency 46 42 945 940 f, FREQUENCY (MHz) Figure 2. Power Gain and Input VSWR versus Frequency 44 935 930 32 29 f = 925 MHz 26 940 MHz 23 20 960 MHz Vbias = 15 Vdc TC = 25°C 17 14 11 24 24.5 25 25.5 26 26.5 27 27.5 TC, CASE TEMPERATURE (°C) VS, SUPPLY VOLTAGE (Vdc) Figure 6. Output Power at 1 dB Compression versus Temperature Figure 7. Output Power at 1dB Compression versus Supply Voltage MOTOROLA RF DEVICE DATA 28 MHW916 3 PACKAGE DIMENSIONS –A– G –B– Y 0.89 (0.035) R T A M NOTES: 1. DIMENSIONING AND TOLERANCING PER ANSI Y14.5M, 1982. 2. CONTROLLING DIMENSION: INCH. 3. DIMENSION F TO CENTER OF LEADS. 4. REF INDICATES NON–CONTROLLED DIMENSION FOR REFERENCE USE ONLY. M –S– J 1 2 3 4 5 K Q 2 PL 0.50 (0.020) M V L W T S 0.25 (0.010) M N H D 5 PL 0.64 (0.025) M T B E F P 5 PL 0.25 (0.010) M M A M INCHES MIN MAX 1.890 1.910 1.170 1.190 0.350 0.376 0.018 0.022 0.120 0.135 0.165 BSC 1.600 BSC 1.055 BSC 0.336 0.360 0.225 ––– 0.255 BSC 0.955 BSC 0.008 0.012 0.151 0.161 0.685 0.705 0.598 0.612 0.155 BSC 0.355 BSC 0.210 REF STYLE 1: PIN 1. 2. 3. 4. 5. CASE: C –T– SEATING PLANE T S DIM A B C D E F G H J K L N P Q R S V W Y MILLIMETERS MIN MAX 48.01 48.51 29.72 30.23 8.89 9.55 0.46 0.56 3.05 3.43 4.19 BSC 40.64 BSC 26.80 BSC 8.53 9.14 5.72 ––– 6.48 BSC 24.26 BSC 0.20 0.31 3.84 4.09 17.40 17.91 15.19 15.55 3.94 BSC 9.02 BSC 5.33 REF RF INPUT +DC (BIAS) +DC (SUPPLY) +DC (SUPPLY) RF OUTPUT GROUND T CASE 301AB– 02 ISSUE H Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or incidental damages. “Typical” parameters which may be provided in Motorola data sheets and/or specifications can and do vary in different applications and actual performance may vary over time. All operating parameters, including “Typicals” must be validated for each customer application by customer’s technical experts. Motorola does not convey any license under its patent rights nor the rights of others. Motorola products are not designed, intended, or authorized for use as components in systems intended for surgical implant into the body, or other applications intended to support or sustain life, or for any other application in which the failure of the Motorola product could create a situation where personal injury or death may occur. Should Buyer purchase or use Motorola products for any such unintended or unauthorized application, Buyer shall indemnify and hold Motorola and its officers, employees, subsidiaries, affiliates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or unauthorized use, even if such claim alleges that Motorola was negligent regarding the design or manufacture of the part. Motorola and are registered trademarks of Motorola, Inc. Motorola, Inc. is an Equal Opportunity/Affirmative Action Employer. Mfax is a trademark of Motorola, Inc. How to reach us: USA / EUROPE / Locations Not Listed: Motorola Literature Distribution; P.O. Box 5405, Denver, Colorado 80217. 1–303–675–2140 or 1–800–441–2447 JAPAN: Nippon Motorola Ltd.: SPD, Strategic Planning Office, 141, 4–32–1 Nishi–Gotanda, Shagawa–ku, Tokyo, Japan. 03–5487–8488 Customer Focus Center: 1–800–521–6274 Mfax: [email protected] – TOUCHTONE 1–602–244–6609 ASIA/PACIFIC: Motorola Semiconductors H.K. Ltd.; 8B Tai Ping Industrial Park, Motorola Fax Back System – US & Canada ONLY 1–800–774–1848 51 Ting Kok Road, Tai Po, N.T., Hong Kong. 852–26629298 – http://sps.motorola.com/mfax/ HOME PAGE: http://motorola.com/sps/ MHW916 4 ◊ MHW916/D MOTOROLA RF DEVICE DATA