CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS LF Radial Lead Type, Standard series Ultra Low ESR, High ripple current. Load life of 2000 hours at 105°C. Radial lead type : Lead free flow soldering condition correspondence. Adapted to the RoHS directive (2002/95/EC). Specifications Item Performance Characteristics Category Temperature Range – 55 ~ +105°C Rated Voltage Range 2.5 ~ 16V Rated Capacitance Range 270 ~ 1000µF Capacitance Tolerance ± 20% at 120Hz, 20°C tan δ Not more than value of Standard ratings at 120Hz, 20°C ESR ( Not more than value of Standard ratings at 100kHz, 20°C 1) Leakage Current ( Not more than value of Standard ratings. 2) After 2 minute's application of rated voltage. Characteristics of Temperature Impedance Ratio Z+105°C / Z+20°C Z– 55°C / Z+20°C Endurance After 2000 hours' application of rated voltage at 105°C, capacitors meet the specified value for life characteristics listed at right. 1.25 1.25 (100kHz) After 1000 hours' application of rated voltage at 60°C 90%RH, capacitors meet the specified value for life characteristics listed at right. Damp Heat 20°C Resistance to Soldering Heat To comply with recommended conditions for reflow soldering. Pre-heating shall be done at 150 ~ 200°C and for 60 ~ 180 sec. Peak temp. is 265°C, within 10 sec. Measurement for solder temperature profile shall be made at a point on the terminal nearest where the terminals protrude through the soldering side of PC board. Marking Navy blue print on the case top Capacitance change tan δ ESR ( 1) Leakage current ( 2) Capacitance change tan δ ESR ( 1) Leakage current ( 2) Capacitance change tan δ ESR ( 1) Leakage current ( 2) Within ± 20% of initial value ( 3) 150% or less of the initial specified value 150% or less of the initial specified value Initial specified value or less Within ± 20% of initial value ( 3) 150% or less of the initial specified value 150% or less of the initial specified value Initial specified value or less Within ± 10% of initial value ( 3) 130% or less of the initial specified value 130% or less of the initial specified value Initial specified value or less 1 ESR measurements should be made at a point on the terminal nearest the end seal of the capacitor. 2 Conditioning : If there is doubt about the measured result, measurement should be made again after the rated voltage is applied for 120 minutes at the temperature of 105°C. 3 Initial value : The value before test of examination of resistance to soldering. Type numbering system (Example : 4V 560µF) Dimensions Silvered lead Wire Laminated Case Capacitance φ D+0.5 MAX. Taping code P ±0.5 6 X 1 g 5 6 0 L F Voltage(g:4V) φd Series Lot. No. L+0.5MAX. 15MIN 4MIN (mm) Size φD L P φd φ8 × 9L 8.0 8.5 3.5 0.6 φ8 × 12L φ10 × 13L 8.0 10.0 11.5 12.5 3.5 5.0 0.6 0.6 Voltage V 2.5 4 6.3 10 16 Code e g j A C Please refer to page 21 about the end seal configulation. Dimension table in next page. CAT.8100V CONDUCTIVE POLYMER ALUMINUM SOLID ELECTROLYTIC CAPACITORS LF series Standard ratings Case Size φD×L (mm) tan δ Leakage Current (0.2CV)(µA) ESR (mΩ) Rated ripple (at 100kHz 20˚C) (mArms) 560 8×9 0.08 280 6 4800 PLF0E561MCO1 680 8 × 12 0.08 340 6 5700 PLF0E681MDO1 820 8×9 0.08 410 7 5200 PLF0E821MCO6 820 8 × 12 0.08 410 6 6200 PLF0E821MDO1 1000 10 × 13 0.08 500 6 6500 PLF0E102MDO1 560 8×9 0.08 448 7 5200 PLF0G561MCO6 560 8 × 12 0.08 448 7 5500 PLF0G561MDO1 680 8 × 12 0.08 544 6 6200 PLF0G681MDO1 820 10 × 13 0.08 656 6 6500 PLF0G821MDO1 470 8×9 0.08 592 7 5200 PLF0J471MCO6 470 8 × 12 0.08 592 7 5500 PLF0J471MDO1 680 10 × 13 0.08 857 6 6300 PLF0J681MDO1 10 (1A) 270 8 × 12 0.08 540 8 4900 PLF1A271MDO1 470 10 × 13 0.08 940 7 5700 PLF1A471MDO1 16 (1C) 270 8 × 12 0.08 864 9 4800 PLF1C271MDO1 470 10 × 13 0.08 1504 9 5000 PLF1C471MDO1 Rated Voltage (V) (code) 2.5 (0E) 4 (0G) 6.3 (0J) Rated Capacitance (µF) No marked, 1 will be put at 12th digit of type numbering system. : In this case, 6 will be put at 12th digit of type numbering system. Part Number Rated Ripple (mArms) at 105°C 100kHz Taping specifications are given in page 24. Please refer to page 3 for the minimum order quantity. CAT.8100V