Fast Ethernet SFP Transceiver SP-FE-LX Features • Compliant with OC3/STM-1, IEEE 802.3ah, 100BASE-LX10 • Single 3.3 V Supply • 10 dB Minimum Link Budget • 15 km Minimum Reach • 1310nm FP Laser • Commercial Temperature Available (-Cxx) • Industrial Temperature Available (-Txx) • SFP MSA SFF-8074i Compliant • Telcordia GR-468 Compliant • Digital Diagnostic SFF-8472 Compliant • Color coded bail latch tube: Grey • RoHS-5/6 compliant product (lead exemption) (-xxA) • RoHS-6/6 compliant product (lead free soldering) (-xxC) General operating Parameter Supply Voltage Total Current Symbol Min. Typical Max. Unit Vcc 3.135 3.3 3.465 V Icc - - 300 mA Power Supply Noise Rejectiona PSR 100 - - mVp-p Operating Temperature (-Cxx) Top -5 - 70 ºC Operating Temperature (-Txx) Top -40 - 85 ºC Storage Temperature Tst -40 - 85 ºC Data Rate DR 10 125 155 Mbps Symbol Min Typical Max Unit POP -15 -11 -8 dBm Average Launch Power Of Off Tx POff - - -45 dBm Extinction Ratio ER 6.6 - - dB a)20 Hz to 155 MHz Transmitter Specifications Parameter Optical Power Eye Mask IEEE 802.3ah and SONET/SDH Compliant Optical Rise Timeb tr - Optical Fall Timeb tf - Mean Wavelength λ 1260 Δλ ORLT Spectral Width (RMS) Optical Return Loss Tolerance - 2 ns 2 ns 1310 1360 nm - - 7.7 nm - - 12 dB b) 20%-80% values LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 1 LUMNDS856-Dec0806 Rev A.1 Fast Ethernet SFP Transceiver SP-FE-LX Transmitter Specifications (Electical) Parameter Symbol Min Typical Max Unit Rin 80 100 120 Ω PECL Single Ended Data Input Swing Vin,p-p 250 - 1200 mV TxFault_Fault Vfault 2 - Vcc V Vnormal Vee - Vee+0.5 V Vd 2 - Vcc V Ven Vee - Vee+0.8 V Symbol Min Typical Max Unit Input Differential Impedence TxFault_Normal TxDisable_Disable TxDisable_Enable Receiver Specifications Parameter Receive Power Lowc Rsens,low - -34 -25 dBm Receive Power High Rsens,high -8 - - dBm Damage Threshold For Receiver Pin,damage 0 - - dBm λ 1260 1310 1360 nm -44 - - dBm Los De-assert - - -25 dBm Los Hysteresis 0.5 - - dB Wavelengthd Los Assert c) 27-1 PRBS, BER 10-12 d) Operational over 1200 to 1625 nm range Electrical Output Parameter Symbol Min Typical Max Unit PECL Single Ended Data Output Swing Vout, p-p 185 - 800 mV Data Output Rise Time tr - - 2 ns Data Output Fall Time tf - - 2 ns Timing and Electrical Parameter Symbol Min Typical Max Unit Tx Disable Negate Time t_on - - 25 ms Tx Disable Assert Time t_off - - 10 µs Time To Initialize, Including Reset Of Tx Fault t_init - - 300 ms Tx Fault Assert Time t_fault - - 100 µs Tx Disable To Reset t_reset 10 - - µs Los Assert Time t_loss_on - - 300 µs Los De-assert Time t_loss_off - - 100 µs Serial ID Clock Rate f_serial_clock - - 100 KHz RX_LOS Voltage (High) 2 - - V RX_LOS Voltage (Low) - - 0.8 V VLOS fault 2 - Vcc V Los Output Voltage-Fault VLOSnormal Vee - Vee+0.5 V MOD_DEF (0:2)-High Los Output Voltage-Normal Vh 2 - Vcc V MOD_DEF (0:2)-LOW Vl Vee - Vee+0.5 V LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 2 LUMNDS856-Dec0806 Rev A.1 Fast Ethernet SFP Transceiver SP-FE-LX Digital Diagnostics Parameter Range Accuracy Unit Temperature (-CDx) -5 to 70 ±3 ºC Temperature (-TDx) -40 to 85 ±3 Voltage 0 to Vcc 0.1 Bias Current 0 to 120 Tx Power Rx Power Calibration Bit Value Formula Internal 1/256 C Tc(C) = Tad(16 bit signed twos complement)/256 ºC Internal 1/256 C V Internal 100µV 5 mA External - I(mA) = Islope * Iad(16 bit unsigned integer)+Ioffset -15 to -8 ±3 dBm External - Tx_PWR(µW) = Tx_PWRslope*Tx_PWRad(16 bit unsigned integer)+Tx_PWRoffset -25 to -8 ±3 dBm External - Rx_PWR(µW) = A0+A1*x+A2*x^2+A3*x^3+A4*x^4 Tc(C) = Tad(16 bit signed twos complement)/256 V(Volts) = Vad(16 bit unsigned integer)*0.1 EEPROM Serial ID Name of Field Vendor Name Vendor OUI Vendor PN LUMINENTOIC.COM Description of Field SFP Vendor name(ASCII) IEEE vendor OUI code for LuminentOIC Inc. Part number in ASCII, e.g. SP-FE-LX-CDA Address Hex 20 4C L 21 55 U 22 4D M 23 49 I 24 4E N 25 45 E 26 4E N 27 54 T 28 4F O 29 49 I 30 43 C 37 00 38 06 39 B5 40 53 S 41 50 P 42 46 F 43 45 E 44 4C L 45 58 X 46 43 C 47 44 D 48 41 A 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 3 ASCII LUMNDS856-Dec0806 Rev A.1 Fast Ethernet SFP Transceiver SP-FE-LX Pinout Definitions Pin Function 1 VeeT Notes TX GND 2 TX_FAULT Open Collector 3 TX_DISABLE Internally Pulled High 4 MOD_DEF2 Serial Data Input 5 MOD_DEF1 Serial Clock Input 6 MOD_DEF0 Internally Grounded 7 NC Not Connected 8 LOS Open Collector 9 VeeR RX Ground 10 VeeR RX Ground 11 VeeR RX Ground 12 RXD- RX Data Negative 13 RXD+ RX Data Positive 14 VeeR RX GND 15 VccR RX Power 16 VccT TX Power 17 VeeT TX GND 18 TXD+ TX Data Positive 19 TXD- TX Data Negative 20 VeeT TX GND LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 4 LUMNDS856-Dec0806 Rev A.1 Fast Ethernet SFP Transceiver SP-FE-LX Outline drawing Units in mm(inches) LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 5 LUMNDS856-Dec0806 Rev A.1 Fast Ethernet SFP Transceiver SP-FE-LX Suggested Transceiver Interface 1�H Vcc 10�F 1�H 0.1�F VCCT .01�F Protocol IC R1 LuminentOIC SFP 10K� TX_DISABLE TX_DISABLE TX_FAULT TX_FAULT TD + SerDes Laser Driver .01�F 100� TD VEET .01�F VCCR 10�F 0.1�F RD + Receiver Amplifier .01�F 100� RD - RX_LOS RX_LOS Vcc R VEER 1 R1 R1 .01�F EEPROM R1 MOD_DEF 2 MOD_DEF 1 MOD_DEF 0 R1=4.7K to 10K� LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 6 LUMNDS856-Dec0806 Rev A.1 Fast Ethernet SFP Transceiver SP-FE-LX Ordering Information Available Options: SP-FE-LX-CDA SP-FE-LX-CDC SP-FE-LX-CNA SP-FE-LX-CNC SP-FE-LX-TDA SP-FE-LX-TDC SP-FE-LX-TNA SP-FE-LX-TNC Part numbering Definition: SP - FE - LX - Temperature Diagnostic Revision • SP= Small Form Pluggable • Data Rate FE = Fast Ethernet (100 Mbps) • Standard LX = 100BASE-LX10 • Operating Temperature C = Commercial temperature (-5 to 70ºC) T = Industrial temperature (-40 to 85ºC) • D = Digital diagnostic (SFF-8472) N = No Digital diagnostic • Design Revision A = RoHS-5/6 compliant product (lead exemption) C = RoHS-6/6 compliant product (no exemption) Warnings: Handling Precautions: This device is susceptible to damage as a result of electrostatic discharge (ESD). A static free environment is highly recommended. Follow guidelines according to proper ESD procedures. Laser Safety: Radiation emitted by laser devices can be dangerous to human eyes. Avoid eye exposure to direct or indirect radiation. Legal Notes: IMPORTANT NOTICE! All information contained in this document is subject to change without notice, at LuminentOIC’s sole and absolute discretion. LuminentOIC warrants performance of its products to current specifications only in accordance with the company’s standard one-year warranty; however, specifications designated as “preliminary” are given to describe components only, and LuminentOIC expressly disclaims any and all warranties for said products, including express, implied, and statutory warranties, warranties of merchantability, fitness for a particular purpose, and non-infringement of proprietary rights. Please refer to the company’s Terms and Conditions of Sale for further warranty information. LuminentOIC assumes no liability for applications assistance, customer product design, software performance, or infringement of patents, services, or intellectual property described herein. No license, either express or implied, is granted under any patent right, copyright, or intellectual property right, and LuminentOIC makes no representations or warranties that the product(s) described herein are free from patent, copyright, or intellectual property rights. Products described in this document are NOT intended for use in implantation or other life support applications where malfunction may result in injury or death to persons. LuminentOIC customers using or selling products for use in such applications do so at their own risk and agree to fully defend and indemnify LuminentOIC for any damages resulting from such use or sale. THE INFORMATION CONTAINED IN THIS DOCUMENT IS PROVIDED ON AN “AS IS” BASIS. Customer agrees that LuminentOIC is not liable for any actual, consequential, exemplary, or other damages arising directly or indirectly from any use of the information contained in this document. Customer must contact LuminentOIC to obtain the latest version of this publication to verify, before placing any order, that the information contained herein is current. © LuminentOIC, Inc. 2003 All rights reserved LUMINENTOIC.COM 20550 Nordhoff St. • Chatsworth, CA 91311 • tel: 818.773.9044 • fax: 818.576.9486 9F, No 81, Shui Lee Rd. • Hsinchu, Taiwan, R.O.C. • tel: 886.3.5169222 • fax: 886.3.5169213 7 LUMNDS856-Dec0806 Rev A.1