VECTRON TFS70AU

Filename: tfs 70au.doc
Version 1.2
VI TELEFILTER
10.01.2006
Filter specification
TFS 70AU
1/5
Measurement condition
Ambient temperature:
Input power level:
Terminating impedance: *
Input:
Output:
25
0
°C
dBm
36 Ω || 158 pF
62 Ω || 123 pF
Characteristics
Remark:
The reference level for the relative attenuation arel of the TFS 70AU is the minimum of the pass band attenuation amin. The minimum of the pass band
attenuation amin is defined as the insertion loss ae. The centre frequency fc is the arithmetic mean value of the upper and lower frequencies at the 3 dB
filter attenuation level relative to the insertion loss ae. The nominal frequency fN is fixed at 70,0 MHz without any tolerance. The given values for both the
relative attenuation arel and the group delay ripple have to be achieved at the frequencies given below even if the centre frequency fc is shifted due to the
temperature coefficient of frequency TCf in the operating temperature range and due to a production tolerance for the centre frequency fc.
Data
typ. value
Insertion loss
(reference level)
ae
8,8
Nominal frequency
fN
-
fC **
Centre frequency
Passband
PB
1
3
40
fN 25,0
MHz … fN 6
9
MHz … fN +
230
fN +
Group delay ripple within PB (p-p)
12,0
dB
70,0
MHz
max.
fN
± 4,375
dB
max.
1,2
9,2
9,7
11,8
min.
min.
max.
8,7
9,4
12,0
50
50
80
min.
min.
max.
-
± 60
MHz
MHz
OTR
40
40
150
+ 28 °C ... + 32°C
Operable temperature range
-
- 40 °C ... + 85°C
Storage temperature range
-
- 40 °C ... + 85°C
Temperature coefficient of frequency
MHz
dB
MHz
MHz
MHz
arel
-
Operating temperature range
kHz
BW
dB
dB
dB
Relative attenuation
max.
MHz
0,8
Pass band ripple (p-p)
Bandwidth
70,0
dB
tolerance / limit
TCf ***
-94
ppm/K
dB
dB
ns
-
*) The terminating impedances depend on parasitics and q-values of matching elements and the board used, and are to be understood as reference
values only. Should there be additional questions do not hesitate to ask for an application note or contact our design team.
**) at 30°C
***) ∆fc(Hz) = Tcf(ppm/K) x (T - TA) x fCAT (MHz)
Generated:
Checked / Approved:
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 70au.doc
Version 1.2
VI TELEFILTER
10.01.2006
Filter specification
TFS 70AU
2/5
0
2.16
-1
2.04
-20
-2
1.92
-30
-3
1.8
-40
-4
1.68
-5
1.56
-6
1.44
-70
-7
1.32
-80
-8
1.2
-90
-9
1.08
-50
-60
-100
45
50
55
60
65
70
75
frequency in MHz
80
85
90
-10
65
95
66
67
68
69
70
71
frequency in MHz
72
73
74
delay in µs
0
-10
magnitude in dB
magnitude in dB
Filter characteristic
0.96
75
Construction and pin connection
(All dimensions in mm)
TFS 70AU
●
T38
6,8Max.
13,6Max.
2,54 ±0,15
1,5
2,54 ±0,15
1 2 3 4
2,0Max.
1
12
5
11
6
Date code
1
2
3
4
5
6
7
8
9
10
11
12
Ground
Ground
Ground
Ground
Output
Output RF Return
Ground
Ground
Ground
Ground
Input
Input RF Return
Date code:
T
U
V
...
Year + week
2005
2006
2007
10 9 8 7
0,1
0,8
50 Ω Test circuit
L1
11
12
5
SAW
L2
6
C2
C1
1, 2, 3, 4, 7, 8, 9, 10
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 70au.doc
Version 1.2
VI TELEFILTER
10.01.2006
Filter specification
TFS 70AU
3/5
Stability characteristics
After the following tests the filter shall meet the whole specification:
1. Shock:
500g, 1 ms, half sine wave, 3 shocks each plane;
DIN IEC 68 T2 - 27
2. Vibration:
10 Hz to 500 Hz, 0,35 mm or 5 g respectively, 1 octave per min, 10 cycles per plan, 3 plans;
DIN IEC 68 T2 - 6
3. Change of
temperature:
4. Resistance to
solder heat (reflow):
-55 °C to 125°C / 30 min. each / 10 cycles
DIN IEC 68 part 2 – 14 Test N
reflow possible: twice max.;
for temperature conditions refer to the attached "Air reflow temperature conditions" on page 4;
Packing
Tape & Reel:
IEC 286 – 3, with exeption of value for N and minimum bending radius;
tape type II, embossed carrier tape with top cover tape on the upper side;
max. pieces of filters peer reel:
reel of empty components at start:
reel of empty components at start including leader:
trailer:
1700
min. 300 mm
min. 500 mm
min. 300 mm
Pull Off Direction
Tape (all dimensions in mm)
W
: 24,00 +0,30/-0,10
Po
: 4,00 ± 0,1
Do
: 1,50 +0,1/0
E
: 1,75 ± 0,10
F
: 11,50 ± 0,10
G(min)
: 0,60
P2
: 2,00 ± 0,1
P1
: 12,00 ± 0,1
D1(min)
: 1,50
Ao
: 7,10 ± 0,10
Bo
: 13,90 ± 0,10
Ct
: 21,5 ± 0,1
t
P1
Date Code
Po
P2
W
G
Ct
Bo
F
G
E
Do
Ko
Typ
PIN Marker
D1
Ao
W 2
Reel (all dimensions in mm)
A
: 330
W1
: 24,4 +2/-0
W2(max) : 30,4
N(min)
: 60
C
: 13,0 +0,5/-0,2
A
C
N
W 1
The minimum bending radius is 45 mm.
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 70au.doc
Version 1.2
VI TELEFILTER
10.01.2006
Filter specification
TFS 70AU
4/5
Air reflow temperature conditions
Conditions
Average ramp-up rate (30°C to 217°C)
> 100°C
> 150°C
> 217°C
Peak temperature
Time within 5°C of actual peak temperature
Cool-down rate (Peak to 50°C)
Time from 30°C to Peak temperature
Exposure
less than 3°C/second
between 300 and 600 seconds
between 240 and 500 seconds
between 30 and 150 seconds
max. 260°C
between 10 and 30 seconds
less than 6°C/second
no greater than 300 seconds
Chip-mount air reflow profile
Temperature / °C
max. 260°C
217°C
max. 300 s
10 ... 30 s
Time / s
30 ... 150 s
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.
Filename: tfs 70au.doc
VI TELEFILTER
Version 1.2
Filter specification
10.01.2006
TFS 70AU
5/5
History
Version
Reason of changes
Name
Date
1.0
- Generation of development specification
Strehl
14.06.2005
1.1
- filter specification generated, 40 dB bandwidth adjusted, 40 dB limits added
Steiner
16.09.2005
1.2
- changed terminating impedances
Chilla
10.01.2006
Tele Filter GmbH
Potsdamer Straße 18
D 14 513 TELTOW / Germany
Tel: (+49) 3328 4784-0 / Fax: (+49) 3328 4784-30
E-Mail: [email protected]
VI TELEFILTER reserves the right to make changes to the product(s) and/or information contained herein without notice. No liability is
assumed as a result of their use or application. No rights under any patent accompany the sale of any such product(s) or information.