Oscilent Corporation RF SAW Filter | 802-RF860.5M-B Page 1 of 3 RF SAW Filter Part Number Package Application Last Modified 802-RF860.5M-B 3.0 x 3.0 SMD iDEN Rx Jan. 01, 2007 . TYPE : Low-Loss RF SAW Filter For iDEN Rx PART NUMBER : 802-RF860.5M-B .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Center Frequency (Fo) Maximum Insertion Loss Stop Band Attenuation: Condition Minimum Typical Maximum Units - - 860.5 - MHz 851.0~ 870.0 MHz - 2.2 3.0 dB D.C.~ 806.0 MHz 45 55 - 806.0~821.0 MHz 40 47 - 896.0~ 902.0MHz 28 34 - 905.825~ 924.825 MHz 30 39 - dB 960.0~ 979.0 MHz 37 53 - 1070.0~ 1089.0 MHz 47 51 - 1089.0~ 3000.0 MHz 27 32 - 851.0~ 870.0MHz - 0.6 1.5 dBp-p Source Impedence (single ended)* - - 50 - ohm Load Impendance (single ended)* - - 50 - ohm VSWR 851.0~ 870.0 MHz - 1.6 2.0 - Group delay ripple 851.0~ 870.0MHz - 15 40 nsp-p Maximum DC Voltage - - - 5 V Maximum Input Power - - - 15 dBm Operating Temperature - -30 - +70 ºC Amplitude Ripple * No Matching Network(Ref. Testing Enviroment Circut as shown below) . PACKAGE OUTLINE (mm) PIN LAYOUT TEST FIXTURE A Ground B Out C Ground D Ground E In F Ground Oscilent Corporation RF SAW Filter | 802-RF860.5M-B Load/ Source Impedance = 50 ohms FREQUENCY RESPONSE VSWR SMITH CHART Page 2 of 3 Oscilent Corporation RF SAW Filter | 802-RF860.5M-B Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 802-RF860.5M-B