Oscilent Corporation IF SAW Filter | 805-IF360.0M-A Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 805-IF360.0M-A 5.0 x 5.0 SMD Mobile Communication May 22 2003 . TYPE : IF Filter for GSM, PCN system PART NUMBER : 805-IF360.0M-A .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units - - 360 - MHz - - 4.8 5.2 dB Fo ± 0.4 ~ Fo ± 0.6 MHz 29 38 - Fo ± 0.6 ~ Fo ± 0.8 MHz 42 53 - Fo ± 0.8 ~ Fo ± 1.6 MHz 42 55 - Fo ± 1.6 ~ Fo ± 5.0MHz 45 55 - Fo ± 5.0 ~ Fo ± 30.0 MHz Center Frequency (Fo) Insertion Loss (a min.) Relative Attenutation dB 50 57 - Amplitude Ripple Fo ± 67.7 KHz - 0.8 1.5 Group Delay Ripple Fo ± 67.7 KHz - 0.7 2.0 us dB FTC - - 0.032 - ppm/ºC² Terminating Impedance - - 50 - ohm DC Voltage - - 0 - V Input Power - - 5 - dBm Operating Temperature - -20 - +75 ºC Storage Temperature - -35 - +85 ºC * Maximum Rating (Ta = 25ºC) ** Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) PIN LAYOUT A In B Ground C Ground D Ground E Out F Ground G Ground H Ground TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_805_if360_0a.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 805-IF360.0M-A L1 = 68nH C1 = 7pF L2 = 74nH C2 = 7pF Page 2 of 3 Source/Load Impedance = 50 ohms FREQUENCY RESPONSE http://www.oscilent.com/spec_pages/if_sawfilter/if_805_if360_0a.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 805-IF360.0M-A Page 3 of 3 Part No.: 805-IF360.0M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_805_if360_0a.htm 12/28/2005