Oscilent Corporation IF SAW Filter | 811-SL200.0M-05 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 811-SL200.0M-05 11.6 x 5.0 SMD Base Station & Repeater Apr 18, 2007 . TYPE : 200.0 MHz Bandpass SAW Filter Low Loss PART NUMBER : 811-SL200.0M-05 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency - Insertion Loss at Fo - 200.0 - MHz 11.8 13.0 Source Impedance (single ended)* dB - 50 - ohm Load Impedance (single ended)* - 50 - ohm Bandwidth at -1.0 dB 4.5 5.09 - MHz Bandwidth at -3.0 dB 5.5 5.92 - MHz Bandwidth at -40.0 dB - 8.68 10.0 MHz Relative Attenuation: (Ref 200MHz) - - - - At 170 / 230 MHz 50 57 - dB Ultimate Rejection 45 - - dB Amplitude Ripple (Fo +/- 2.05MHz) - 0.6 1.0 dBp-p Group Delay Variation (Fo +/- 2.05MHz) - 100 150 nsec Absolute Delay at Fo - 0.98 - µsec Temperature Coefficient - -23 - ppm/°C In/Out Return Loss at Fo - - - dB *With Matching Network (Reference Testing Environment Circuit as shown) Modifiy Impedance Values as necessary. . PACKAGE OUTLINE (mm) TEST FIXTURE PIN Description IN-1,OUT-7, GROUND-2,3,4,5,6,8,9,10 Oscilent Corporation IF SAW Filter | 811-SL200.0M-05 Page 2 of 2 FREQUENCY RESPONSE Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 811-SL200.0M-05