Oscilent Corporation IF SAW Filter | 813-SL96.0M-35 Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 813-SL96.0M-35 13.3 x 6.5mm SMD Base Station & Repeater Apr 18, 2007 . TYPE : 96.00 MHz Filter 36.00 MHz Bandwidth PART NUMBER : 813-SL96.0M-35 .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units Center Frequency - 96.0 - MHz Insertion Loss - 16.8 18.5 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm Bandwidth -1.0 dB 35.0 36.0 - MHz Bandwidth -3.0 dB 36.0 36.8 - MHz Bandwidth -30.0 dB - 40.0 41.0 MHz Amplitude Ripple (Fo +/- 2.5MHz) - 0.4 0.7 dBp-p Amplitude Ripple - 1.2 2.0 dBp-p Group Delay Variation - 65 120 nsec Group Delay Variation (Fo +/- 2.5MHz) - 38 70 nsec Absolute Delay - 0.942 - µsec dB 40 47 - Ambient Temperature - 25 - °C Temperature Coefficient - -94 - ppm/°C Relative Attenuation *With Matching Network(ref. Testing Enirovnment Circut as shown below) *Custom parameters available. Contact Oscilent Sales for discussion. . PACKAGE OUTLINE (mm) TEST FIXTURE Oscilent Corporation IF SAW Filter | 813-SL96.0M-35 Page 2 of 2 PIN Descriptions: IN-11, OUT-5, GROUND- 1,2,3,4,6,7,8,9,10,12 L1 = 68nH L2 = 56pF L3 = 56nH L4 = 68pF Source/Load Impedance = 50 ohms Frequency Responce Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 813-SL96.0M-35