Oscilent Corporation IF SAW Filter | 819-IF190.0M-A Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 819-IF190.0M-A 19 x 6.5 SMD Base Station, Repeater, HDR, IMT-2000 May 22 2003 . TYPE : 190.0 MHz Bandpass Filter 1.22 MHz Bandwidth PART NUMBER : 819-IF190.0M-A . Horizontal : 1.0 MHz/Div Veritical : 10 dB/Div Horizontal : 0.2 MHz/Div Veritical : 1 dB/Div Veritical : 100 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 189.95 190.00 190.05 MHz Insertion Loss - 19.0 22.0 dB 1dB Bandwidth 1.10 1.14 - MHz 3dB Bandwidth 1.22 1.30 - MHz 25dB Bandwidth - 1.80 1.85 MHz 33dB Bandwidth - 1.91 1.96 MHz Passband Ripple - 0.50 1.0 dB Center Frequency - 120 200 nsec Ultimate Rejection 32 38 - dB Substrate Material - Quartz - - Ambient Temperature - 25 - °C Phase Linearity - 3.0 7.0 deg Group Delay Variation * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_819_if190_0a.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 819-IF190.0M-A Page 2 of 2 L1 = 56nH L2 = 39nH C1 = 22pF C2 = 27pF Source/Load Impedance = 50 ohms Part No.: 819-IF190.0M-A Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_819_if190_0a.htm 12/28/2005