Oscilent Corporation IF SAW Filter | 835-IF70.0M-P Page 1 of 2 IF SAW Filter Part Number Package Application Last Modified 835-IF70.0M-P 35.0 x 12.8 Thru Hole Base Station & Repeater May 02 2003 . TYPE : 70.0 MHz Bandpass Filter 250 KHz Bandwidth PART NUMBER : 835-IF70.0M-P . Horizontal : 0.3 MHz/Div Veritical : 10 dB/Div Horizontal : 0.06 MHz/Div Veritical : 1 dB/Div Veritical : 200 ns/Div . OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units MHz 69.94 70.00 70.06 Insertion Loss - 17.5 20.0 dB 1dB Bandwidth 0.16 0.18 - MHz 3dB Bandwidth 0.25 0.30 - MHz 40dB Bandwidth - 0.9 1.0 MHz Passband Ripple - 1.2 1.5 dB Group Delay Variation - 300 1000 µsec Center Frequency - 3.7 - µsec Ultimate Rejection 50 60 - dB Substrate Material - Qz - - Ambient Temperature - 25 - °C Absolute Delay * Custom SAW IF Filters available. Contact Oscilent for assistance. . PACKAGE OUTLINE (mm) TEST FIXTURE http://www.oscilent.com/spec_pages/if_sawfilter/if_835_if70_0p.htm 12/28/2005 Oscilent Corporation IF SAW Filter | 835-IF70.0M-P Page 2 of 2 L1 = 120nH C1 = 62pF L2 = 100nH C2 = 27pF Source/Load Impedance = 50 ohms Part No.: 835-IF70.0M-P Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map http://www.oscilent.com/spec_pages/if_sawfilter/if_835_if70_0p.htm 12/28/2005