SUBMINIATURE SOLID STATE LAMP $0<& YELLOW Features Description OWIDE VIEWING ANGLE. The Yellow source color devices are made with Gallium OSUBMINIATURE PACKAGE. Arsenide Phosphide on Gallium Phosphide Yellow Light OYOKE LEAD. OLONG LIFE-SOLID STATE RELIABILITY. Emitting Diode. OLOW PACKAGE PROFILE. OPACKAGE : 1000PCS / REEL. ORoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.25(0.01") unless otherwise noted. 3. Lead spacing is measured where the lead emerge from the package. 4. Specifications are subject to change without notice. SPEC NO: DSAD1317 REV NO: V.2 DATE: MAR/10/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000438 Selection Guide Part No. Dice $0<& Iv (mcd) @ 20mA Lens Type YELLOW (GaAsP/GaP) WATER CLEAR Viewing Angle Min. Typ. 2θ1/2 10 30 20° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device λpeak Peak Wavelength Yellow λD Dominant Wavelength ∆λ1/2 Typ. Max. Units Test Conditions 590 nm IF=20mA Yellow 588 nm IF=20mA Spectral Line Half-width Yellow 35 nm IF=20mA C Capacitance Yellow 20 pF VF=0V;f=1MHz VF Forward Voltage Yellow 2.1 2.5 V IF=20mA IR Reverse Current Yellow 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Yellow Units Power dissipation 105 mW DC Forward Current 30 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage -40°C To +85°C Operating/Storage Temperature Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAD1317 REV NO: V.2 DATE: MAR/10/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000438 Yellow AM27YC08 SPEC NO: DSAD1317 REV NO: V.2 DATE: MAR/10/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000438 AM27YC08 Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows: 1.Wavelength: +/-1nm (Test condition is based on the sorting standard). 2.Luminous intensity: +/-15% (Test condition is based on the sorting standard). 3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard). SPEC NO: DSAD1317 REV NO: V.2 DATE: MAR/10/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: S.H.CHEN ERP:1202000438