Oscilent Corporation IF SAW Filter | 820-IF65.54M-E Page 1 of 3 IF SAW Filter Part Number Package Application Last Modified 820-IF65.54M-E 20.2 x 12.6 Thru Hole Repeater Jan. 01, 2007 . TYPE : 65.54 MHz Bandpass Filter for Gap Filter 19.60 MHz Bandwidth PART NUMBER : 820-IF65.54M-E .. OPERATING CONDITIONS / ELECTRICAL CHARACTERISTICS PARAMETERS Minimum Typical Maximum Units 65.50 65.54 65.58 MHz Insertion Loss at Fo - 25.4 26.5 dB Source Impedance (single ended)* - 50 - ohm Load Impedance (single ended)* - 50 - ohm 1.0dB Bandwidth 18.95 19.23 - MHz 3.0dB Bandwidth 19.35 19.60 - MHz 35.0dB Bandwidth - 20.86 21.00 MHz 40.0dB Bandwidth - 20.93 21.10 MHz Amplitude Ripple 58.0~73.0 MHz - 0.45 0.55 dB Group Delay Variation 58.0~73.0 MHz - 40 100 nsec Center Frequency (Fo) - 2.35 - µsec 55 60 - dB Maximum DC Voltage - - 10 V Maximum Input Power - - 10 dBm Operating Temperature Range -30 - +80 °C Storage Temperature Range -40 - +85 °C Absolute Delay at Fo Ultimate Rejection at Fo +/-20 MHz *With Matching Network (Ref. Testing Environment Circuit as shown below) . PACKAGE OUTLINE (mm) Oscilent Corporation IF SAW Filter | 820-IF65.54M-E PIN DESCRIPTIONS: IN -1, OUT - 5, GROUND -2,3,4,6 TEST CIRCUIT TEST FIXTURE AND VALUES/SOURCE AND LOAD IMPEDANCE 50 ohm INPUT: OUTPUT: L1: 180 nH; C1: 30 pF L2: 180 nH; C2: 30 pF COMPONENT VALUES MAY VARY DUE TO PCB PARASITICS FREQUENCY RESPONSE Page 2 of 3 Oscilent Corporation IF SAW Filter | 820-IF65.54M-E Page 3 of 3 Part No.: Crystal Oscillators | Quartz Crystal | TCXO | VCXO | IF SAW Filter | RF SAW Filter | Ceramic Resonator Crystal Filter | Ceramic Filter | SAW Filter / SAW Devices | Site Map 820-IF65.54M-E