CY241V08A-41 MPEG Clock Generator with VCXO Features • • • • Benefits Integrated phase-locked loop (PLL) Low-jitter, high-accuracy outputs VCXO with analog adjust 3.3V operation • Highest-performance PLL tailored for multimedia applications • Meets critical timing requirements in complex system designs • Application compatibility for a wide variety of designs Frequency Table Part Number Outputs CY241V08A-41 1 Input Frequency Range Output Frequencies VCXO Control Curve 27-MHz pullable crystal input One copy of 27 MHz linear per Cypress specification One copy of 83.33 MHz (non-pullable) Other Features Pinout-compatible with MK3741 Block Diagram PLL 54 REF OUTPUT DIVIDER 83.33MHz 27 XIN XBUF/27MHz OSC XOUT VCXO VDD VSS Pin Configuration CY241V08A-41 8-pin SOIC XIN 1 8 XOUT VDD VCXO 2 7 REF 3 6 83.33 MHz VSS 4 5 XBUF/27 MHz Cypress Semiconductor Corporation Document #: 38-07655 Rev. *A • 3901 North First Street • San Jose, CA 95134 • 408-943-2600 Revised April 22, 2004 CY241V08A-41 Pin Descriptions Name Pin Number Description XIN 1 Reference crystal input. VDD 2 Voltage supply. VCXO 3 Input analog control for VCXO. VSS 4 Ground. XBUF/27 MHz 5 27-MHz buffered crystal output. 83.33 MHz 6 83.33-MHz clock output. REF 7 54-MHz reference input. XOUT 8 Reference crystal output. Document #: 38-07655 Rev. *A Page 2 of 6 CY241V08A-41 Absolute Maximum Conditions Data Retention @ Tj = 125°C................................> 10 years Supply Voltage (VDD) ........................................–0.5 to +7.0V DC Input Voltage...................................... –0.5V to VDD + 0.5 Storage Temperature (Non-condensing)..... –55°C to +125°C Junction Temperature ................................ –40°C to +125°C Package Power Dissipation...................................... 350 mW ESD (Human Body Model) MIL-STD-883................. > 2000V (Above which the useful life may be impaired. For user guidelines, not tested.) Pullable Crystal Specifications[1] Parameter Description Comments FNOM Nominal crystal frequency CLNOM Nominal load capacitance R1 Equivalent series resistance (ESR) R3/R1 Ratio of third overtone mode ESR to fundamental mode ESR DL Crystal drive level Min. Typ. Max. Unit – 27 – MHz – 14 – pF Fundamental mode – – 25 Ω Ratio used because typical R1 values are much less than the maximum spec 3 – – – No external series resistor assumed 150 – – µW Parallel resonance, fundamental mode, AT cut F3SEPHI Third overtone separation from 3*FNOM High side 300 – – ppm F3SEPLO Third overtone separation from 3*FNOM Low side – – –150 ppm C0 Crystal shunt capacitance – – 7 pF C0/C1 Ratio of shunt to motional capacitance 180 – 250 – C1 Crystal motional capacitance 14.4 18 21.6 fF Recommended Operating Conditions Parameter Description VDD Operating Voltage TA Ambient Temperature CLOAD Max. Load Capacitance tPU Power-up time for all VDD pins to reach minimum specified voltage (power ramps must be monotonic) Min. Typ. Max. Unit 3.135 3.3 3.465 V 0 – 70 °C – – 15 pF 0.05 – 500 ms DC Electrical Specifications Parameter Name Min. Typ. Max. Unit VOH = VDD – 0.5V, VDD = 3.3V 12 24 – mA Output LOW Current VOL = 0.5V, VDD = 3.3V 12 24 – mA Input Capacitance Except XIN, XOUT pins – – 7 pF IOH Output HIGH Current IOL CIN VVCXO VCXO Input Range f∆XO[2] VCXO Pullability Range IVDD Supply Current Description 0 – VDD V Low Side – – –115 ppm High Side 115 – – ppm – – 40 mA AC Electrical Specifications (VDD = 3.3V) [3] Parameter[3] Min. Typ. Max. Unit DC Output Duty Cycle Name Duty Cycle is defined in Figure 1, 50% of VDD Description 45 50 55 % ER Rising Edge Rate Output Clock Edge Rate, Measured from 20% to 80% of VDD, CLOAD = 15 pF. See Figure 2. 0.8 1.4 – V/ns EF Falling Edge Rate Output Clock Edge Rate, Measured from 80% to 20% of VDD, CLOAD = 15 pF. See Figure 2. 0.8 1.4 – V/ns Notes: 1. Crystals that meet this specification includes: Ecliptek ECX-5808-27.000M 2. –115/+115 ppm assumes 2.5 pF of additional board level load capacitance. This range will be shifted down with more board capacitance or shifted up with less board capacitance. 3. Not 100% tested. Document #: 38-07655 Rev. *A Page 3 of 6 CY241V08A-41 AC Electrical Specifications (VDD = 3.3V) (continued)[3] Parameter[3] Min. Typ. Max. Unit t9 Clock Jitter 83.33 MHz Name Peak-to-peak period jitter Description – – 500 ps t9 Clock Jitter XBUF/27 MHz Peak-to-peak period jitter – – 375 ps t10 PLL Lock Time – – 3 ms Test and Measurement Set-up VDD Outputs 0.1 µF CLOAD DUT GND Voltage and Timing Definitions t1 t2 VDD 50% of VDD Clock Output 0V Figure 1. Duty Cycle Definition t3 t4 V DD 80% of V DD 20% of V DD Clock Output 0V Figure 2. ER = (0.6 x VDD) /t3, EF = (0.6 x VDD) /t4 Ordering Information Ordering Code Package Name Package Type Operating Range Operating Voltage Features CY241V08ASC-41 S8 8-pin SOIC Commercial 3.3V Linear VCXO control curve CY241V08ASC-41T S8 8-pin SOIC – Tape and Reel Commercial 3.3V Linear VCXO control curve Document #: 38-07655 Rev. *A Page 4 of 6 CY241V08A-41 Package Drawing and Dimensions 8-lead (150-Mil) SOIC S8 8 Lead (150 Mil) SOIC - S08 PIN 1 ID 4 1 1. DIMENSIONS IN INCHES[MM] MIN. MAX. 2. PIN 1 ID IS OPTIONAL, ROUND ON SINGLE LEADFRAME RECTANGULAR ON MATRIX LEADFRAME 0.150[3.810] 0.157[3.987] 3. REFERENCE JEDEC MS-012 0.230[5.842] 0.244[6.197] 4. PACKAGE WEIGHT 0.07gms PART # S08.15 STANDARD PKG. 5 SZ08.15 LEAD FREE PKG. 8 0.189[4.800] 0.196[4.978] 0.010[0.254] 0.016[0.406] SEATING PLANE X 45° 0.061[1.549] 0.068[1.727] 0.004[0.102] 0.050[1.270] BSC 0.004[0.102] 0.0098[0.249] 0°~8° 0.016[0.406] 0.035[0.889] 0.0075[0.190] 0.0098[0.249] 0.0138[0.350] 0.0192[0.487] 51-85066-*C All product or company names mentioned in this document may be the trademarks of their respective holders. Document #: 38-07655 Rev. *A Page 5 of 6 © Cypress Semiconductor Corporation, 2004. The information contained herein is subject to change without notice. Cypress Semiconductor Corporation assumes no responsibility for the use of any circuitry other than circuitry embodied in a Cypress Semiconductor product. Nor does it convey or imply any license under patent or other rights. Cypress Semiconductor does not authorize its products for use as critical components in life-support systems where a malfunction or failure may reasonably be expected to result in significant injury to the user. The inclusion of Cypress Semiconductor products in life-support systems application implies that the manufacturer assumes all risk of such use and in doing so indemnifies Cypress Semiconductor against all charges. CY241V08A-41 Document History Page Document Title: CY241V08A-41 MPEG Clock Generator with VCXO Document Number: 38-07655 REV. ECN NO. Issue Date Orig. of Change ** 213686 See ECN RGL New Data Sheet *A 220421 See ECN RGL Minor Change: To post on web Document #: 38-07655 Rev. *A Description of Change Page 6 of 6