H HiTRON UNIVERSAL AC INPUT HARMONIC CORRECTION AC-DC 6U PENTAD OUTPUT 1000 WATTS VPX SWITCHING POWER SUPPLIES HAV1000 SERIES FEATURES: VITA 62 COMPLIANT 6U VPX POWER SUPPLY WIDE OPERATING TEMPERATURE RANGE OF -40°C TO +85 °C INTERNAL OR-ING DIODES FOR N+1 REDUNDANCY ACTIVE CURRENT SHARING EMI MEET EN 55022 / CLASS A PMBus INTERFACE FOR STATUS & CONTROL SPECIFICATION INPUT SPECIFICATION OUTPUT SPECIFICATION Input Voltage: Typ. 90-264Vac. Power Factor: Meet Harmonic Correction IEC 61000-3-2. Power Factor typ. 0.98-0.99. Input Connector: Tyco 6450843-6. Input Frequency: 47-63Hz. Inrush Current: 10A(rms) at 230Vac; 37.2A (peak) at 230Vac. Input Current: 7.3A at 115Vac / 5.2A at 230Vac. Dielectric Withstand: Meet IEC 60950-1 regulation. EMI: Meet EN 55022 FCC Class A. Hold-up Time: Typ. 6.2mS at 115Vac/2.3mS at 230Vac. Remote ON/OFF: Available. Power Fail Signal: Available. Over Temperature Protection (OTP): Installed NTC and thermostat. Leakage Current: Typ. 1.1mA at 230Vac. No-Load Power: Typ. 11.8Watt at 115Vac & 230Vac. Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Output Power: 700W at 90-180Vac/1000W at 180-264Vac. Output Connector: Tyco 6450849-6. Line Regulation: Typ. 1%. Load Regulation: VO1/2/3 typ. ±2% ; VO4/5 typ. ±5%. Total Regulation: VO1/2/3 typ. ±3%; VO4/5 typ. ±5% Noise & Ripple: Typ. 1.5% pk-pk. OVP: Built-in at all outputs. Adjustability: Available at VO1/2/3. N+1 Redundancy: Installed with internal OR-ing diodes at all outputs and third-wire current sharing method for N+1 redundancy operation. Current Sharing: Active current sharing at VO1,2 & 3. DC OK Signal: Available for all outputs. Power OK Signal: Available for all outputs. Over Current Protection (OCP): Installed at each rail. Overload Protection (OLP): Fully protected against output overload or short circuit. Typ. 110-150% max. load. Consult the factory for special OLP setting. GENERAL SPECIFICATION Efficiency: Typ. 86% at 230Vac. Switching Frequency: 67-100K Hz. Circuit Topology: ZVS Half-Bridge circuit. Transient Response: Peak transient less than 1200mV and recovers within 2ms for 25% load-change. Safety Standard: IEC 60950-1 Class I. PMBus: Built-in. Operating Temperature: -40 °C to +85 °C (see note 3/derating chart) , derate linearly from 100% power at +50 °C to 55% power at +85 °C. Storage Temperature: -45 to +90 °C. Cooling: At least 800LFM moving air is required to achieve full rating power in a confined area. Power Density: 5.8-8.3 Watts/ Cubic Inch. NOTE: (1)All measurement are at nominal input, full load and +25°C unless otherwise specifications. (2)Due to requests in market and advances in technology, specifications subject to change without notification. (3)A warm-up time 3 minutes is required to maintain outputs within specific spec. after cold start at temperature from -40 °C to +0°C. (4)Tantalum capacitors connected to system is suggested for bettering Ripple & Noise against operating temperature from -40°C to +0°C. (5)125 degree C OS-CON Long-life Solid capacitors are installed in secondary circuits. -1- Rev.B Edited on May 1, 2015 OUTPUT VOLTAGE / CURRENT RATINGS CHART QUAD OUTPUT MODEL NO. O/P Volt. VO1 VO2 VO3 VO4 VO5 HAV1000-P120EDII Min. 0A(1.0A) 0A(1.0A) 0A(1.0A) 0A(0.1A) 0A(0.1A) Volt. 12V 5V 3.3V 12V -12V Typ. 55A 25A 20A 1A 1A Max. 60A 30A 25A 2A 2A Peak. 60A 30A 25A 2A 2A Remark: 1. Max. Output power<=700W at 90-180Vac, 1000Watt at 180-264Vac. 2. For parallel application, a certain minimum current of outputs is required. MECHANICAL DIMENSIONS: MM [INCHES] DERATING CHART INPUT & OUTPUT CONNECTORS PIN ASSIGNMENT P0 P1 P0-P7 P0-P4 P0-P1 L N G P1 COM P2 VO3 3.3V Aux. D1 D2 PS_RNT EN P3 P4 P5 P6 D3 D4 D5 D6 N/A A0 N/A SYS RST C1 C2 C3 C4 C5 C6 V3 +S INH N/A A1 N/A VO5 -12V B1 B2 B3 B4 B5 B6 V3 -S FAL VO4 +12V A2 SCL COM COM VO2 P03 +5V VO2 P03 +5V P8 D7 D8 D9 C8 V2 -S B8 C9 V2 +S B9 N/A N/A N/A N/A A7 V1 CS A8 V1 -S A9 V1 +S A2 A3 A4 A5 A6 V3 CS N/A N/A Alert SDA N/A P9 P10 COM DEG. I/P_ok C7 V2 CS B7 A1 -2- P7 COM COM VO1 VO1 P02 P01 +12V +12V Rev.B Edited on May 1, 2015