66136 optical schmitt trigger with ttl buffer

66136
Revision -
Mii
OPTICAL SCHMITT TRIGGER WITH TTL BUFFER
ALL DATA IS PRELIMINARY AND SUBJECT TO CHANGE
WHEN DESIGN IS FINALIZED
5/29/01
Features:
Applications:
•
•
•
•
•
•
•
Optical shmitt-trigger with TTL output
High input sensitivity less than 2 uW
Switching frequency to 1 Mhz
Spectrally matched for LED’s in the 850 to 880
nm range
OPTOELECTRONIC PRODUCTS
DIVISION
Optical sensors
Optical data links
Optical isolators
DESCRIPTION
The 66136 series optical detector contains an integrated optical schmitt-trigger IC with a TTL buffer. The detector has an 18
mil X 18 mil active area coupled to a trans-impedance amplifier which converts the light detected light to a voltage level. This
voltage is compared to an internal threshold and switches when it is greater than the internal reference. The comparator has
built in hysterisis to provide a clean “snap acting” output even for slowly changing light levels. An internal buffer stage
provides “light operated” rise and fall times typically in the 6-10 ns range allowing easy logic interface. The receiver is
designed to operate from a single 5 volt supply and is directly compatible with TTL logic. This receiver may be screened to
MIL-PRF19500 requirements.
ABSOLUTE MAXIMUM RATINGS 25°C FREE AIR TEMPERATURE UNLESS NOTED
Storage Temperature............................................................................................................................................. -55°C to +150°C
Operating Temperature ........................................................................................................................................... -40°C to +85°C
Input Voltage .........................................................................................................................................................................5.5 Vdc
Soldering Temperature (1/16 inch from case for 10 seconds).............................................................................................. 240°C
Transmission Rate at 100mA IF ....................................................................................................................................... 10Mbits/s
NOTES:
Package Dimensions
Schematic Diagram
MICROPAC INDUSTRIES, INC. OPTOELECTRONIC PRODUCTS DIVISION • 725 E. Walnut St., Garland, TX 75040 • (972) 272-3571 • Fax (972) 487-6918
www.micropac.com
E-MAIL: [email protected]
6 - 32
66136
Revision -
OPTICAL SCHMITT TRIGGER WITH TTL OUTPUT
5/29/01
ELECTRICAL CHARACTERISTICS
TA = 25°C unless otherwise specified.
SYMBOL
MIN
TYP
MAX
UNITS
Supply voltage
PARAMETER
Vcc
4.5
5
5.25
V
Input current
Iin
8
Receiver Sensitivity
R
1.5
1
2
Ma.
µW
Vcc = 5 V
850 nm LED
Propagation Delay
Tpdl, Tphl
4
µs
850 nm LED
Output Rise Time
tr
tf
8
15
10
ns
ns
C=15 pf
6
0,5
V
Output Fall Time
Voh
Vol
Output High
Output Low
2.7
3.4
.35
TEST CONDITIONS
NOTE
C=15 pf
Ioh = -.4 ma.
Iol = 4 ma. Vcc = 5.25 V
NOTES:
RECOMMENDED OPERATING CONDITIONS:
PARAMETER
Supply Voltage
SYMBOL
MIN
MAX
UNITS
Vcc
4.5
5.25
mA
SELECTION GUIDE
PART NUMBER
TBD
PART DESCRIPTION
PO Range
TBD
MICROPAC INDUSTRIES, INC. OPTOELECTRONIC PRODUCTS DIVISION • 725 E. Walnut St., Garland, TX 75040 • (972) 272-3571 • Fax (972) 487-6918
www.micropac.com
E-MAIL: [email protected]
6 - 33